Go Back   The Ford Barn > Search Forums
Reload this Page Search Results

Sponsored Links (Register now to hide all advertisements)

Showing results 1 to 9 of 9
Search took 0.00 seconds. Search: Posts Made By: tommy rand
Forum: Model-A 04-29-2019, 10:05 PM
Replies: 0
Views: 920
Posted By tommy rand
Model a ford banjo rear

Looking for a 4:56.1 ring and pinion gear set for a model a ford
Forum: Model-A 04-29-2019, 09:19 PM
Replies: 0
Views: 784
Posted By tommy rand
Model a ford ring and pinion gear

Looking for a 4:56.1 ring and pinion gear set for a model a ford banjo rear end
Forum: Model A (1928-31) 02-19-2016, 12:17 AM
Replies: 20
Views: 6,257
Posted By tommy rand
Re: winfield head

thank you all again for the info
Forum: Model A (1928-31) 02-17-2016, 11:08 PM
Replies: 20
Views: 6,257
Posted By tommy rand
Re: winfield head

where did you get the spacer gasket I also have a Winfield red head that I will be putting on a motor that I plan to build in the future
Forum: Model A (1928-31) 02-16-2016, 08:28 PM
Replies: 20
Views: 6,257
Posted By tommy rand
Re: winfield head

pistons stretch with heat iron stretches when heated don't know at what rate but I needs clearance regardless.
Forum: Model A (1928-31) 02-14-2016, 04:40 PM
Replies: 20
Views: 6,257
Posted By tommy rand
Re: winfield head

the head I have is aluminum so I took the head gasket and a scribe marked over pistons then took a sharpie then got my router and a carbide tip bit and removed the material and with a 90 degree...
Forum: Model A (1928-31) 02-14-2016, 01:57 PM
Replies: 20
Views: 6,257
Posted By tommy rand
Re: winfield head

yes I have I have a 2 port riley that I have had to 5500 repeatly
Forum: Model A (1928-31) 02-13-2016, 09:45 PM
Replies: 20
Views: 6,257
Posted By tommy rand
Re: winfield head

thank all of you for the info
Forum: Model A (1928-31) 02-13-2016, 05:48 PM
Replies: 20
Views: 6,257
Posted By tommy rand
winfield head

I have a rebuilt motor with pistons that come 0.20 over the top deck and a best gasket with a 0.42 compressed thickness will this work with a Winfield head with no relief cut over the pistons the...
Showing results 1 to 9 of 9

 
Forum Jump
Sponsored Links (Register now to hide all advertisements)


All times are GMT -5. The time now is 07:37 PM.