Forum: Late V8
09-04-2015, 08:28 AM
|
Replies: 0
Views: 884
power steering pullys
WANTED- Power steering pullys for 56 ford 292, crankshaft and water pump. Call Chuck at 530 344-0322
|
Forum: Late V8
05-18-2015, 11:46 AM
|
Replies: 0
Views: 895
|
Forum: Late V8
04-05-2015, 06:25 PM
|
Replies: 0
Views: 1,421
54 Ford sunliner convertible top latch handle
I am looking for the chrome latch handle that goes to the top latch in the center of the inside windshield frame of a 1954 Crestliner Sunliner...mine snapped off while locking the top down. call...
|
Forum: Late V8
12-08-2014, 12:12 PM
|
Replies: 0
Views: 1,016
|
Forum: Late V8
10-27-2014, 09:30 AM
|
Replies: 0
Views: 1,029
|
Forum: Late V8 (1954+)
05-30-2014, 01:25 PM
|
Replies: 6
Views: 2,055
Re: 8-lug 16" OEM wheels and disc brakes?
The back of wheel does not clear the caliper by less than an inch which does not allow the wheel to slip on to the lugs. Are you thinking a spacer on the hub might work? I appreciate any help you can...
|
Forum: Late V8 (1954+)
05-30-2014, 01:13 PM
|
Replies: 6
Views: 2,055
Re: 8-lug 16" OEM wheels and disc brakes?
The flange on the back side of the wheel will not clear the caliper by about 3/4 inch or an inch, so the wheel won't slide on to the lugs...you thinking what I've been thinking...put a spacer on the...
|
Forum: Late V8 (1954+)
05-29-2014, 09:45 AM
|
Replies: 6
Views: 2,055
8-lug 16" OEM wheels and disc brakes?
Does anyone know if there exists an 8-lug 16" steel wheel that will fit over the caliper of front disc brakes on a 65 F-250? I'm not sure where the disc brakes are from, but the original steel wheels...
|
Forum: Late V8 (1954+)
05-06-2014, 05:05 PM
|
Replies: 24
Views: 5,453
|
Forum: Late V8 (1954+)
04-30-2014, 11:16 AM
|
Replies: 24
Views: 5,453
Re: Help! Can't get my '54 239 to run right!?
johnsunliner-
The timing is right on the mark, so I don't think it slipped a tooth unless it could do that and still appear correct with the timing light. Is that possible? I'm thinking its...
|
Forum: Late V8 (1954+)
04-30-2014, 11:09 AM
|
Replies: 24
Views: 5,453
Re: Help! Can't get my '54 239 to run right!?
scicala-
Interesting...I have thought the carburetor is the trouble all along. I'm going to pull it off again and check it again...any other suggestions what to look for in the carb? It's the...
|
Forum: Late V8 (1954+)
04-30-2014, 01:44 AM
|
Replies: 24
Views: 5,453
Re: Help! Can't get my '54 239 to run right!?
George/Maine,
I'm thinking the problem could be the distributor itself...I will pull it out and check it... Do you have any suggestions regarding how to tell what might be wrong/worn out, etc...?
|
Forum: Late V8 (1954+)
04-30-2014, 01:34 AM
|
Replies: 24
Views: 5,453
Re: Help! Can't get my '54 239 to run right!?
jeffB2-
I'll try to replace the power valve, but it was replaced with the one that came with the kit when I rebuilt the carb. Could be it's not the real Holley part you mention. I'll check it...
|
Forum: Late V8 (1954+)
04-30-2014, 01:29 AM
|
Replies: 24
Views: 5,453
|
Forum: Late V8 (1954+)
04-30-2014, 01:25 AM
|
Replies: 24
Views: 5,453
Re: Help! Can't get my '54 239 to run right!?
Justold-
Timing is right on at 8 degrees advanced. Fuel delivery is fine, engine turns normally, starts right up and runs terribly, won't idle, popping and sputtering with lots of rich smoke out...
|
Forum: Late V8 (1954+)
04-30-2014, 01:19 AM
|
Replies: 24
Views: 5,453
|
Forum: Late V8 (1954+)
04-29-2014, 09:37 AM
|
Replies: 24
Views: 5,453
Help! Can't get my '54 239 to run right!?
My 54 Sunliner with a stock 239 fordomatic lost power the other day and limped home acting fuel starved and barely running...I have replaced points, plugs, distributor cap and rotor, rebuilt the...
|
Forum: Questions & Suggestions
03-23-2014, 10:36 PM
|
Replies: 3
Views: 1,094
Re: '54 239 4 barrel conversion
Thanks, Paul...I will re-post this in the correct forum. I am trying to find a 54 Merc linkage and/or a 56 Ford linkage as well. Wish me luck!
|
Forum: Late V8
03-23-2014, 01:43 PM
|
Replies: 0
Views: 1,197
4-barrel Holley teapot linkage '54 239
I'm looking for a linkage that will work on a '54 Merc intake and Holley teapot setup that I want to install on my '54 Sunliner 239 Fordomatic. The 239 has the stock pedal and kick-down rods and I...
|
Forum: Questions & Suggestions
03-22-2014, 12:15 AM
|
Replies: 3
Views: 1,094
|
Forum: Late V8 (1954+)
03-07-2014, 02:10 AM
|
Replies: 6
Views: 1,742
Re: 54 Sunliner trm code
Thanks, John...I think you may be correct that the second "B" is code for a black convertible top. My car has a white top that's shot and I was thinking of installing a black one, now I'm convinced.
|
Forum: Late V8 (1954+)
03-07-2014, 02:06 AM
|
Replies: 6
Views: 1,742
|
Forum: Late V8 (1954+)
02-18-2014, 05:57 AM
|
Replies: 64
Views: 131,842
|
Forum: Late V8 (1954+)
02-18-2014, 01:50 AM
|
Replies: 6
Views: 1,742
|
Forum: Late V8
02-08-2014, 10:42 AM
|
Replies: 0
Views: 1,436
1954 Ford 239
I am looking for a "Police Interceptor" 4-barrel intake manifold and carburetor for a stock '54 Ford 239 V8.
I am also looking for a "Coronado" trunk lid for a '54 Customline Sunliner. This was...
|