Forum: Late V8 (1954+)
06-25-2023, 10:18 PM
|
Replies: 42
Views: 4,252
|
Forum: Model A (1928-31)
05-26-2020, 11:27 AM
|
Replies: 25
Views: 5,668
|
Forum: Model A (1928-31)
02-07-2016, 05:08 PM
|
Replies: 29
Views: 6,391
|
Forum: Model A (1928-31)
12-27-2015, 08:35 PM
|
Replies: 24
Views: 4,283
Re: Model A won't start
I have had problems when my car sits usually winter to spring, most of the time I clean points and then check for spark , always worked for me.
|
Forum: Model A (1928-31)
12-09-2015, 09:20 PM
|
Replies: 21
Views: 5,028
|
Forum: Model A (1928-31)
11-21-2015, 11:47 AM
|
Replies: 42
Views: 7,124
|
Forum: Model A (1928-31)
11-11-2015, 11:14 AM
|
Replies: 27
Views: 5,243
Re: Leaky Gas Guage
if you use any flame to repair tank make sure you clean to properly prevent possibility of explosion!
|
Forum: Model A (1928-31)
10-08-2015, 10:59 AM
|
Replies: 21
Views: 9,668
Re: No more stalls at stop signs for me!
I had a problem with stalling at stops when I searched the problem I found the gas linkage was slightly bent causing idle on high speed circuit. Bent linkage so throttle closed and engine idled on...
|
Forum: Model A (1928-31)
08-31-2015, 10:11 AM
|
Replies: 14
Views: 3,189
Re: throwout bearing Q...
I had three different ones with three different manufacturers Germany, mexico, and U.S they all sounded dry when I spun them.I was concerned so I packed grease in from any lip and joint I could find,...
|
Forum: Model A (1928-31)
08-11-2015, 10:31 AM
|
Replies: 15
Views: 2,505
Re: Please ID these
possibly for the brake actuator rod and cup on the end where it joins with king pin.
|
Forum: Model A (1928-31)
07-14-2015, 04:05 PM
|
Replies: 23
Views: 4,853
Re: Where to start ??
I had a bad vibration when I applied brakes,found a nut on my front spring perch under axel was loose.
|
Forum: Model A (1928-31)
07-13-2015, 02:19 PM
|
Replies: 45
Views: 9,289
Re: Model A power
You may be running too rich by opening gav too much. Half to 3/4 for start and 1/4 to run when warm some say to close when on highway.
|
Forum: Model A (1928-31)
06-13-2015, 02:09 PM
|
Replies: 43
Views: 11,677
Re: Enigine work
I,d clean it first before jumping to any conclusion. I,be seen worse clean up o.k.
|
Forum: Model A (1928-31)
06-02-2015, 01:44 PM
|
Replies: 4
Views: 1,465
|
Forum: Model A (1928-31)
05-31-2015, 11:45 PM
|
Replies: 10
Views: 2,720
|
Forum: Model A (1928-31)
05-27-2015, 07:00 PM
|
Replies: 23
Views: 5,941
Re: Best plugs..??
I use 3076 auto lite plugs gapped at .032, cam high compression head 5.5,runs excellent.
|
Forum: Model A (1928-31)
05-16-2015, 06:23 PM
|
Replies: 9
Views: 2,322
Re: what plugs needed
I use auto lite 3076 because they're inexpensive and work well, cost around 3.00 each.
|
Forum: Model A (1928-31)
05-16-2015, 02:03 PM
|
Replies: 6
Views: 2,334
Re: engine noise
thanks Bill hopefully mine will too. I have about 1000 miles on it now, I may try a fiber gear.
|
Forum: Model A (1928-31)
05-16-2015, 09:19 AM
|
Replies: 6
Views: 2,334
Re: engine noise
the noise is from timing gear region I've used a stethoscope tool to narrow it down, I think James is correct when I looked nothing appeared to stand out as the cause of noise. Aside from noise it's...
|
Forum: Model A (1928-31)
05-15-2015, 10:34 PM
|
Replies: 6
Views: 2,334
engine noise
I have a noise in my engine, there since day one of new engine, it's a clack or slap noise. Re set lifters no differance still there, removed timing cover to see if spring on cam plunger broken or...
|
Forum: Model A (1928-31)
05-08-2015, 08:12 AM
|
Replies: 14
Views: 3,442
Re: sign in
same problem ,easy enough I just have to remember my password.
|
Forum: Model A (1928-31)
02-25-2015, 08:04 PM
|
Replies: 15
Views: 3,109
|
Forum: Model A (1928-31)
02-12-2015, 10:16 AM
|
Replies: 74
Views: 31,068
Re: Fuel Filter
I placed a 4 inch speaker magnet by my gas outlet of my tank, I think it's helped keep the rust out of carb. I also placed a filter or trap from one of the parts suppliers in the sediment bowl, every...
|
Forum: Model A (1928-31)
01-18-2015, 04:52 PM
|
Replies: 112
Views: 35,397
Re: White Wall Tires????
A friend of mine saw the white walls on my 30 roadster and liked them so much he went out and put 4 new whitewalls on his roadster. Thing is I don't really like the whitewalls on my car, go figure.
|
Forum: Model A (1928-31)
12-26-2014, 12:44 PM
|
Replies: 15
Views: 3,979
Re: Bushing/Spring Perch
I always press a bit then lightly tap for vibration to release any stress has worked very well. I'f you have a helper get them to lightly tap while you press.
|