Go Back   The Ford Barn > Search Forums

Sponsored Links (Register now to hide all advertisements)

Showing results 1 to 25 of 136
Search took 0.01 seconds.
Search: Posts Made By: ckulchar
Forum: Model A (1928-31) 11-25-2020, 07:30 AM
Replies: 4
Views: 613
Posted By ckulchar
Oil pressure and water pipe question

My friend that recently purchased the 1928 Phaeton has a few more questions. He'd like some advice on.

There was an oil filter added to the engine. There is an oil pressure gauge mounted below...
Forum: Model A (1928-31) 11-23-2020, 02:29 PM
Replies: 19
Views: 781
Posted By ckulchar
Re: Remove sludge from bottom of gas tank

He purchased the car out of Florence Mass. It was and still shown on the hcca.org website for sale section. Nice car.

Best
Charley
Forum: Model A (1928-31) 11-22-2020, 03:57 PM
Replies: 19
Views: 781
Posted By ckulchar
Re: Remove sludge from bottom of gas tank

Called my friend. He will try and scoop some out tomorrow and advise me.
Forum: Model A (1928-31) 11-22-2020, 03:29 PM
Replies: 19
Views: 781
Posted By ckulchar
Remove sludge from bottom of gas tank

A friend recently purchased a 1928 Phaeton. The car had been sitting three years. The fuel bowl was removed from the tank and fuel drained. That left about 1" of sludge on the bottom.

Ideas to...
Forum: Model-A 06-23-2020, 06:14 PM
Replies: 0
Views: 403
Posted By ckulchar
Wanted: Three spoke generator pulley.

Need a long nose three spoke generator pulley and a good cut-out

Thanks in advance.
Charley
Forum: Late V8 10-17-2019, 05:53 PM
Replies: 0
Views: 302
Posted By ckulchar
Wanted right front fender 1958 Ford Fairlane

Need excellent right front fender for a 1958 Ford Fairlane. Ohio area preferred for pick up. Other areas if you can ship via Fastenal.
Please PM.
Thanks
Charley
Forum: Model A (1928-31) 08-05-2019, 06:35 AM
Replies: 7
Views: 729
Posted By ckulchar
Re: Sparking at starter switch

Purchased a new starter switch and that fixed the problem.
Appreciate everyone's help.
Charley
Forum: Model A (1928-31) 08-02-2019, 07:39 AM
Replies: 7
Views: 729
Posted By ckulchar
Sparking at starter switch

Yesterday we drove the 1931 pickup. Started four or five times without any issues. Last night when I attempted to start the vehicle to put in the garage. While holding the starting foot pedal down I...
Forum: Model A (1928-31) 02-23-2019, 05:21 PM
Replies: 70
Views: 5,266
Posted By ckulchar
Re: What's the latest you can remember anyone using an A?

Remember delivering newspapers in the late 60's. A gentleman drove a black Model A coupe as his everyday car. Brush painted with patch panels everywhere. I really wanted that car.

Charley
Forum: Model A (1928-31) 02-23-2019, 05:15 PM
Replies: 70
Views: 5,266
Posted By ckulchar
Re: What's the latest you can remember anyone using an A?

Growing old is a privilege denied to many!

Charley
Forum: Model A (1928-31) 01-05-2019, 06:58 AM
Replies: 58
Views: 6,704
Posted By ckulchar
Re: Tom Endy

Tom
Best wishes for a speedy recovery!
Charley
Forum: Model A (1928-31) 07-31-2018, 03:29 PM
Replies: 19
Views: 1,759
Posted By ckulchar
Re: Saved A-nother one

Nice truck. A friend in need is a friend indeed!
Charley
Forum: Model A (1928-31) 07-30-2018, 05:32 AM
Replies: 12
Views: 1,612
Posted By ckulchar
Re: 1931 Wide Bed Pickup body...

I have a Budd cab wide bed truck if that will help.
Charley
Forum: Model A (1928-31) 07-16-2018, 02:52 PM
Replies: 5
Views: 643
Posted By ckulchar
Re: Rear axle change 1931 ccpu

Did Ford use the 3:54 or 3:27 in a production A or are those two ratios aftermarket?

Thanks again
Forum: Model A (1928-31) 07-16-2018, 12:31 PM
Replies: 5
Views: 643
Posted By ckulchar
Rear axle change 1931 ccpu

We have a 1931 ccpu. I'm sure the rear end is a 4:11. Top speed in the truck is about 35 or so with the engine racing quite high.

A friend has a spare rear end we determined to be 3:78. Would this...
Forum: Late V8 05-31-2018, 12:57 PM
Replies: 0
Views: 548
Posted By ckulchar
Wtd Herbrand HT-660 coil tester

Would like to purchase an operable Herbrand Ht-660 Coil Tester.

Thanks in advance

Charley
Forum: Early V8 05-31-2018, 12:56 PM
Replies: 0
Views: 339
Posted By ckulchar
Wtd Herbrand HT-660 coil tester

Would like to purchase an operable Herbrand Ht-660 Coil Tester.

Thanks in advance

Charley
Forum: Model-A 05-29-2018, 11:03 AM
Replies: 0
Views: 445
Posted By ckulchar
Herbrand Ht-660 Coil Tester

Would like to purchase an operable Herbrand Ht-660 Coil Tester.

Thanks in advance

Charley
Forum: Model A (1928-31) 08-21-2017, 11:20 AM
Replies: 37
Views: 2,963
Posted By ckulchar
Re: Burial

Bill
Sorry for your loss.
Charley
Forum: Model A (1928-31) 07-04-2017, 08:18 PM
Replies: 3
Views: 592
Posted By ckulchar
How to determine gear ratio on rear end out of vehicle?

Have a 1931 ccpu with a low gear ratio probably stock. My friend has three spare rear end assemblies. How would we determine the gear ratio of these units? What ratio would I want to use to get a...
Forum: Model A (1928-31) 03-01-2017, 07:22 AM
Replies: 34
Views: 4,140
Posted By ckulchar
Re: Best way to enter and exit 31 CCPU

I used to be addicted to the hokey pokey.
Then I turned myself around.
Now I'm only addicted to old automobiles.
Charley
Forum: Model A (1928-31) 02-09-2017, 09:29 PM
Replies: 344
Views: 36,240
Posted By ckulchar
Forum: Model A (1928-31) 01-09-2017, 06:52 PM
Replies: 21
Views: 3,603
Posted By ckulchar
Re: Pictures from 1965

Thanks for sharing all the great photos.

charley
Forum: Model A (1928-31) 11-19-2016, 06:50 AM
Replies: 28
Views: 5,953
Posted By ckulchar
Re: found an A for sale

Appears to be late model 1931 steel top with wide bed. Radiator shell, headlights, and cowl band have been changed.
charley
Forum: Model-T 10-11-2016, 05:30 PM
Replies: 0
Views: 1,119
Posted By ckulchar
Wanted 21" split rim 1926-27

Need one very good to excellent 21" split rim with the round hole tab.
Thanks in advance.
Charley
Showing results 1 to 25 of 136

 
Forum Jump
Sponsored Links (Register now to hide all advertisements)


All times are GMT -5. The time now is 10:20 AM.