Go Back   The Ford Barn > Search Forums
Reload this Page Search Results

Sponsored Links (Register now to hide all advertisements)

Showing results 1 to 8 of 8
Search took 0.00 seconds. Search: Posts Made By: hubercats
Forum: Early V8 (1932-53) 01-01-2022, 01:20 PM
Replies: 23
Views: 3,116
Posted By hubercats
Re: 41 ford car stock gas tank sending unit - recommendation

@JayChicago: Thank you, and Happy New Year!
Forum: Early V8 (1932-53) 12-31-2021, 03:57 PM
Replies: 23
Views: 3,116
Posted By hubercats
Re: 41 ford car stock gas tank sending unit - recommendation

@JayChicago: Out of curiosity, did you place the 7 Ohm resistor in series with the gauge or in parallel? My gut instinct suggests placing it in series. Thanks!
Forum: Early V8 (1932-53) 02-22-2021, 10:03 AM
Replies: 45
Views: 5,822
Posted By hubercats
Re: Flathead V8 Distributor Slot in Cam shaft

Very impressive setup!
Forum: Early V8 (1932-53) 02-18-2021, 11:22 AM
Replies: 45
Views: 5,822
Posted By hubercats
Re: Flathead V8 Distributor Slot in Cam shaft

Thanks, Mart. I wasn’t questioning the utility of the tie wrap method. Rather I was just noting that it had been a topic of discussion in the Australian forum. I’m a big fan of “good enough for the...
Forum: Early V8 (1932-53) 02-17-2021, 05:50 PM
Replies: 45
Views: 5,822
Posted By hubercats
Re: Flathead V8 Distributor Slot in Cam shaft

I agree that TDC is TDC. That doesn't mean that the method for estimating TDC (with the heads on the engine) is necessarily perfect. So that people can judge for themselves, here is the web page...
Forum: Early V8 (1932-53) 02-17-2021, 05:04 PM
Replies: 45
Views: 5,822
Posted By hubercats
Re: Flathead V8 Distributor Slot in Cam shaft

I've seen some comments on the internet where people are questioning the accuracy of finding top dead center using methods such as the cable tie approach on account of the fact that the crankshaft in...
Forum: Early V8 (1932-53) 02-16-2021, 09:20 PM
Replies: 45
Views: 5,822
Posted By hubercats
Re: Flathead V8 Distributor Slot in Cam shaft

Veeder's brother here: A quick note on the plot that Veeder posted. The blue ramps are from the Hall Effect angle sensor. Because of the way the sensor mounts to the stepper motor shaft, the angle...
Forum: Early V8 (1932-53) 02-16-2021, 02:32 PM
Replies: 45
Views: 5,822
Posted By hubercats
Re: Flathead V8 Distributor Slot in Cam shaft

Veeder's brother here: As regards our reinventing a Sun distributor test machine, that really hasn't been our goal. Our goal was/is to build a machine that allows us to do initial setup of a newly...
Showing results 1 to 8 of 8

 
Forum Jump
Sponsored Links (Register now to hide all advertisements)


All times are GMT -5. The time now is 04:35 AM.