Forum: Late V8 (1954+)
12-16-2022, 07:47 AM
|
Replies: 21
Views: 3,243
|
Forum: Late V8 (1954+)
12-16-2022, 07:44 AM
|
Replies: 6
Views: 1,100
|
Forum: Late V8 (1954+)
12-14-2022, 08:02 AM
|
Replies: 21
Views: 3,243
|
Forum: Late V8 (1954+)
10-18-2022, 07:26 AM
|
Replies: 7
Views: 1,350
|
Forum: Late V8 (1954+)
10-11-2022, 10:47 AM
|
Replies: 13
Views: 2,023
Re: 55 Ford Ranch Wagon Wiper Motor.
you can get a refurbished unit from concours.
https://www.parts123.com/parts123/yb.dll?parta~dyndetail~Z5Z5Z50000051e~Z5Z5Z516203~P149.95~~~~S6G60P509G65302122630c~Z5Z5Z5~Z5Z5Z50000051e
|
Forum: Late V8 (1954+)
10-11-2022, 07:24 AM
|
Replies: 24
Views: 3,252
Re: 1956 sunliner restoration
My dad wanted me to put disc on his 56 Sunliner. After much research I talked him out of it. I did put a manual Dual master. Rebuilt the drums all around. It stops great. I put disc on my 55...
|
Forum: Late V8 (1954+)
10-03-2022, 04:49 PM
|
Replies: 24
Views: 3,252
|
Forum: Late V8 (1954+)
10-03-2022, 08:57 AM
|
Replies: 24
Views: 3,252
Re: 1956 sunliner restoration
Only thing to do on that car is put a white top on it and change the horn ring. Sure hope all that stuff is staying with the car and not ending up on craigslist or facespace.
|
Forum: Late V8 (1954+)
09-26-2022, 08:36 AM
|
Replies: 6
Views: 1,086
Re: losing another Boneyard
I should've put it in the original post Zeb's 715-754-5885, the last I heard they are only open Mon-Wed and Sat till noon now.
Tell the GM guys too. I wish I could get there more but a few hours...
|
Forum: Late V8 (1954+)
09-25-2022, 09:56 AM
|
Replies: 6
Views: 1,086
losing another Boneyard
Just thought I would throw this out there.
Zeb's in Tigerton Wisconsin will not be around too much longer. The land was sold for Deer hunting and everything is getting crushed.
Most has been...
|
Forum: Late V8 (1954+)
09-06-2022, 05:25 PM
|
Replies: 19
Views: 3,077
Re: Preserving ‘patina’
Great tutorial here with Derek from Vice Grip Garage
OPERATION PRESERVE PATINA! Buffing Oxidized Paint and Applying Linseed Oil - Vice Grip Garage EP56
https://youtu.be/HD7AvQZoYcU
|
Forum: Late V8 (1954+)
08-13-2022, 09:25 AM
|
Replies: 13
Views: 1,549
|
Forum: Late V8 (1954+)
08-13-2022, 09:23 AM
|
Replies: 13
Views: 1,549
|
Forum: Late V8 (1954+)
08-12-2022, 12:29 PM
|
Replies: 13
Views: 1,549
|
Forum: Late V8 (1954+)
08-12-2022, 08:19 AM
|
Replies: 13
Views: 1,549
Re: 56 ford car front end sheet metal
Correct, the ones for the top of the Aprons are the longer ones and as stated in a earlier reply seem to be impossible to find. I guess I will need to find a parts car or switch thread size. Was...
|
Forum: Late V8 (1954+)
08-11-2022, 04:04 PM
|
Replies: 13
Views: 1,549
56 ford car front end sheet metal
Another question for you guys. I'm trying to locate the cage nuts for the top of the wheel well where the fender attaches. According to the book it calls for 359952-S. This is the same # used at...
|
Forum: Late V8 (1954+)
08-04-2022, 10:38 AM
|
Replies: 2
Views: 595
|
Forum: Late V8 (1954+)
07-28-2022, 08:50 PM
|
Replies: 10
Views: 1,483
Re: 56 Conv top experts
Went back in and cycled a few times to bleed and double check fill. All good no change.
Parts came from Hydro E Lectric. The top has been manually put up and down since the rams were...
|
Forum: Late V8 (1954+)
07-26-2022, 09:54 PM
|
Replies: 10
Views: 1,483
Re: 56 Conv top experts
I'm hoping to get over to the shop tomorrow and give it another couple of cycles and see if I can get any air out. Hopefully that does it. I'll report back.
Thanks for the input
|
Forum: Late V8 (1954+)
07-26-2022, 07:50 AM
|
Replies: 13
Views: 2,028
Re: Removing body bolts
Not sure on this vehicle but does it extend through the floor where the threads are visible underneath? I've had luck on this double nutting it and then running it back through the top. At least to...
|
Forum: Late V8 (1954+)
07-26-2022, 06:53 AM
|
Replies: 10
Views: 1,483
Re: 56 Conv top experts
Using ATF in the pump. I'm going to cycle it a few more times and make sure there isn't air in the system. No instructions came with it so I just followed the orig shop manual.
I can see the air...
|
Forum: Late V8 (1954+)
07-25-2022, 07:29 PM
|
Replies: 10
Views: 1,483
56 Conv top experts
Looking for some input on the power top. My Dad has owned this car since 1982 (2nd owner) and the top has never worked. I've been working on things for him and I just replaced they cylinders,...
|
Forum: Late V8 (1954+)
05-18-2022, 03:45 PM
|
Replies: 7
Views: 1,084
Re: 1956 Convertible top switch rebuild
Merc, I was on my way to Ace after your first reply. Thanks again for the help and follow up. For a couple bucks it works perfect. For future reference I only needed one spring, cut in half. The...
|
Forum: Late V8 (1954+)
05-18-2022, 07:40 AM
|
Replies: 7
Views: 1,084
Re: 1956 Convertible top switch rebuild
Thank you! That is exactly what I needed. Seems the brass contact strip has evaporated and the springs have broken in mine. I thought there needed to be a strip there to make contact.
|
Forum: Late V8
05-17-2022, 03:07 PM
|
Replies: 0
Views: 624
1956 Body Bolts
Looking for original body bolts (4), the ones behind the front seat. 3" though the floor pan to brace. Could use washers and grommet if useable. Thanks
|