Forum: Early V8 (1932-53)
04-20-2024, 03:55 PM
|
Replies: 23
Views: 1,245
|
Forum: Early V8 (1932-53)
04-18-2024, 11:47 PM
|
Replies: 9
Views: 461
|
Forum: Early V8 (1932-53)
04-15-2024, 09:20 PM
|
Replies: 50
Views: 1,880
Re: 91 birthday today
Happy 91st Ol' Ron. Your wisdom on the Ford flathead engines, and
your willingness to share it with others, so they can keep those
engines in fine running condition, is Priceless. :):):)
You are...
|
Forum: Early V8 (1932-53)
04-09-2024, 02:46 PM
|
Replies: 7
Views: 424
|
Forum: Early V8 (1932-53)
04-07-2024, 10:12 AM
|
Replies: 7
Views: 502
Re: Lake Pipe insalation
I know he has a '49 Ford car he wants to put them on.
I would call Speedway and perhaps they could see if
another box of pipes has the instructions and make a copy.
Also, ask to talk to one of...
|
Forum: Early V8 (1932-53)
04-06-2024, 11:56 PM
|
Replies: 7
Views: 502
Re: Lake Pipe insalation
Are there any brackets that came with the pipes ?
If so, can you describe the brackets to us ?
.
|
Forum: Early V8 (1932-53)
03-30-2024, 02:26 PM
|
Replies: 9
Views: 575
Re: 1949 Ford Custom Body measurements
================================================
Hi Al, just curious, do you know that a 15" wheel will actually measure
a little over 16 inches, outer edge to outer edge of the wheel...;)
...
|
Forum: Early V8 (1932-53)
03-29-2024, 11:04 AM
|
Replies: 21
Views: 1,158
|
Forum: Early V8 (1932-53)
03-28-2024, 08:11 PM
|
Replies: 21
Views: 1,158
Re: rear drum studs
Yes, your '47 wheel will fit the '40 drum, but as has been said, the
lug studs on the '40 drum will be to short for a safe fit of the '47
wheel.
The '40 and the '47 wheels have different styled...
|
Forum: Late V8 (1954+)
03-07-2024, 07:07 PM
|
Replies: 7
Views: 442
|
Forum: Model A (1928-31)
02-24-2024, 09:26 PM
|
Replies: 25
Views: 1,915
|
Forum: Early V8 (1932-53)
02-23-2024, 11:43 PM
|
Replies: 8
Views: 570
Re: 40 ford wiper transmissions
I have one driver side wiper tower for a '40 closed car that I could send pix of.
PM me an email addy if you have any interest in one...
.
|
Forum: Early V8 (1932-53)
02-05-2024, 12:55 AM
|
Replies: 31
Views: 2,124
Re: To use in hose thermostats or not? 1935 85 V8
Scuba,,, listen to the advice of both 'tubman' and 'cas3'.
You should always run thermostats, look for any cooling
problems elsewhere. Clean both the radiator and block,
and make sure the timing...
|
Forum: Early V8 (1932-53)
01-15-2024, 11:22 PM
|
Replies: 43
Views: 3,258
|
Forum: Early V8 (1932-53)
01-14-2024, 09:45 PM
|
Replies: 21
Views: 1,111
Re: Clutch won’t release
Paul, have you got a good open space to drive the truck around
on your property. If you have some space to drive it in circles,
then put it in gear, hold the clutch pedal down, and start it up...
|
Forum: Early V8 (1932-53)
01-14-2024, 04:22 PM
|
Replies: 34
Views: 1,319
|
Forum: Early V8 (1932-53)
01-14-2024, 12:31 AM
|
Replies: 24
Views: 1,015
|
Forum: Early V8 (1932-53)
12-21-2023, 08:57 PM
|
Replies: 35
Views: 2,673
Re: Violent shake.
Terry, I read where you installed most all the New clutch parts,
but curious, did you install a New Pilot bearing/bushing too ?
A wore out pilot bearing/bushing will cause one heck of a shake.
...
|
Forum: Early V8 (1932-53)
12-19-2023, 11:50 PM
|
Replies: 21
Views: 1,383
|
Forum: Early V8 (1932-53)
12-17-2023, 11:41 PM
|
Replies: 5
Views: 685
|
Forum: Early V8 (1932-53)
12-17-2023, 10:25 PM
|
Replies: 21
Views: 1,383
Re: 1940 Deluxe coupe, cowl " water catch tray''
Zeke, that is Not a water tray. It is the tray for the Gasket to set into.
Someone has put in that Little drain...
Do a search for a "cowl gasket" for your car. I think '37 to '48 are all the same...
|
Forum: Early V8 (1932-53)
12-17-2023, 09:12 PM
|
Replies: 21
Views: 1,383
Re: 1940 Deluxe coupe, cowl " water catch tray''
================================================
Hi Zeke, I had a '37 Ford coupe many-many years ago, and I remember
replacing that worn-out cowl gasket ,to stop the water from leaking in.
There...
|
Forum: Late V8 (1954+)
12-11-2023, 10:06 PM
|
Replies: 5
Views: 922
Re: 1940 Ford big boy seat base
Hi Terry, good for you, that you drug a 1940 Ford truck
out from "rotting away" in a barn, and getting it back on
the road. I hope you get lots of enjoyment out of it.
.
|
Forum: Early V8 (1932-53)
12-11-2023, 09:45 PM
|
Replies: 80
Views: 6,154
Re: Jim Linder aka Bubba
Yup, Bubba, Rest in Peace... By the testimony of
a great share of the members here, he was an
easy person to talk to, and get advice from.
Condolences to Jim's family. He will be Missed.
...
|
Forum: Early V8 (1932-53)
12-07-2023, 10:45 PM
|
Replies: 51
Views: 2,986
Re: Remember Pearl Harbor
Back in 1941, this great country had some of the best and smartest
armies and leaders in the world, and had some very good planes and
the best fighting equipment at that time.
That is what it...
|