Forum: Model A (1928-31)
Yesterday, 01:06 AM
|
Replies: 9
Views: 533
Re: Batteries completely discharging
Do you have a pop-out (original type) ignition switch? If so, it is possible that the switch is shorting the hot to ground when off. Feel the coil after the car is off for several minutes. If the...
|
Forum: Model A (1928-31)
04-22-2024, 09:28 AM
|
Replies: 17
Views: 833
|
Forum: Model A (1928-31)
04-22-2024, 01:25 AM
|
Replies: 17
Views: 833
|
Forum: Model A (1928-31)
04-21-2024, 06:27 PM
|
Replies: 29
Views: 1,536
Re: Distributor Cap Advance Lever Slot
Excellent question, Jim!
I just measured an original cap. The slot is 1-1/32" wide.
Here is an original cap and a good quality repro next to each other. The original is on the right side of...
|
Forum: Model A (1928-31)
04-21-2024, 01:47 PM
|
Replies: 29
Views: 1,536
Re: Distributor Cap Advance Lever Slot
What about if you have one of the repro caps where the opening is not wide enough? The poor repro opening is only 3/4 the width of the factory cap opening.
|
Forum: Model A (1928-31)
04-21-2024, 12:50 PM
|
Replies: 17
Views: 833
|
Forum: Model A (1928-31)
04-21-2024, 12:45 PM
|
Replies: 6
Views: 462
Re: getting into the Rumble Seat
There is no safe way (to my knowledge) of getting in or out of a rumble seat unless you stand on the seat. I ask (demand) riders remove shoes first.
This link- ...
|
Forum: Model A (1928-31)
04-21-2024, 10:27 AM
|
Replies: 29
Views: 1,536
Re: Distributor Cap Advance Lever Slot
That slot is indeed there to act as a stop at each end of travel of the upper plate. If there were no stops, it could be possible to over-rotate the upper plate and it could pop out of the slot in...
|
Forum: Model A (1928-31)
04-21-2024, 10:16 AM
|
Replies: 17
Views: 833
|
Forum: Model A (1928-31)
04-20-2024, 10:23 AM
|
Replies: 27
Views: 1,663
Re: Recommended Turning Signal Switch
Bert's Model A Center is a very reputable vendor. Steve Becker is on these forums.
Which turn signal unit is the one I used in today's video?- https://www.youtube.com/watch?v=tjQnlw5WGCU
|
Forum: Model A (1928-31)
04-19-2024, 09:40 AM
|
Replies: 8
Views: 761
Re: Help! Metal Valve Stems
I have a how-to video in production to show how. If you feel like driving to Calaveras County, I can do them.
|
Forum: Model A (1928-31)
04-17-2024, 05:50 PM
|
Replies: 44
Views: 8,808
Re: Aries Stainless Steel Muffler
Here is a video of Joe Davis himself talking about this subject- https://www.youtube.com/watch?v=fMeM5WbKkOg
Here is a video comparing the Aries steel muffler to the other repro one-...
|
Forum: Model A (1928-31)
04-14-2024, 02:38 PM
|
Replies: 17
Views: 844
Re: engine slows when advance timing
Other possibility is the distributor upper plate. Some of the repro plates position the points in a location so that when the points just open (to cause the coil to produce the spark), the rotor is...
|
Forum: Model A (1928-31)
04-13-2024, 07:14 PM
|
Replies: 17
Views: 844
Re: engine slows when advance timing
Never assume the #1 piston is at TDC when the timing pin finds the dimple on the timing gear. Pull the #1 cylinder spark plug and use a flashlight to look in and verify.
|
Forum: Model A (1928-31)
04-09-2024, 11:41 AM
|
Replies: 14
Views: 783
Re: Condenser Capacity
That trick about having a spare condenser attached to the wire loom clip on the firewall with an alligator clip is genius! I'm going to make some up right now.
Since the condenser is one of the...
|
Forum: Model A (1928-31)
04-08-2024, 04:31 PM
|
Replies: 14
Views: 783
Re: Condenser Capacity
That's a good article, Tom.
One line that might be troublesome for someone who does not yet know the Model A wiring inside the distributor is, "You can easily test a condenser while it is still...
|
Forum: Model A (1928-31)
04-08-2024, 09:48 AM
|
Replies: 14
Views: 783
Re: Condenser Capacity
Using FETs to trigger a field breakdown (that's what makes the spark) in a coil, some FETs have capacitance already, so the capacitance needed for the "LC circuit" is minimal. A small surface mount...
|
Forum: Model A (1928-31)
04-08-2024, 09:43 AM
|
Replies: 14
Views: 783
Re: Condenser Capacity
The weird part is, the actual value of the capacitor (condenser) isn't nearly as critical as it's leakage (acting like a resistor). The only time you would have to increase the capacitance is when...
|
Forum: Model A (1928-31)
04-04-2024, 10:45 AM
|
Replies: 33
Views: 3,259
Re: Marco Tahtaras
Marco was SO kind and generous with myself and others with his knowledge and parts stash. The first time I met him in person was at his house, Marco was showing me some details on his nearly perfect...
|
Forum: Model A (1928-31)
04-01-2024, 08:07 AM
|
Replies: 26
Views: 2,199
|
Forum: Model A (1928-31)
03-31-2024, 07:32 PM
|
Replies: 28
Views: 1,677
Re: Electric Model A's
Let us not forget that there were many electric cars on the road when the Model A was new. They were primarily marketed toward those in big cities and to ladies.
|
Forum: Model A (1928-31)
03-26-2024, 10:18 AM
|
Replies: 5
Views: 937
Re: RIP John Phillips Model A Garage
Very sorry you heard it from me. When I left you that VM, I wasn't even thinking. Should have waited and called when you could answer in person. I'm sorry about that.
|
Forum: Model A (1928-31)
03-24-2024, 01:55 PM
|
Replies: 20
Views: 1,251
Re: spark plugs
3X spark plugs are more difficult to foul than a more modern plug like the W18's. They were designed to be reliable even with 1920's grade fuels and lubricants, all of which were worse than anything...
|
Forum: Model A (1928-31)
03-24-2024, 09:26 AM
|
Replies: 20
Views: 1,448
Re: Best riding A?
Best (softest) ride Model A I own is the 29 fordor. The wood body cars also tend to be quieter. Ride comfort is a lot of factors combined. Springy springs (they stiffen as they age), proper shock...
|
Forum: Model A (1928-31)
03-23-2024, 01:14 AM
|
Replies: 3
Views: 391
|