Go Back   The Ford Barn > Search Forums
Reload this Page Search Results

Sponsored Links (Register now to hide all advertisements)

Showing results 1 to 9 of 9
Search took 0.00 seconds. Search: Posts Made By: grinch
Forum: Early V8 (1932-53) 12-03-2012, 06:03 PM
Replies: 2
Views: 1,485
Posted By grinch
Thread size on early ford tie rods

Anyone know the thread size on early ford tie rods? I thought they were 11/16 X 18. Some are saying 11/16 X 24? Never run into a 24?? Thanks
Forum: Early V8 07-30-2012, 01:38 PM
Replies: 3
Views: 927
Posted By grinch
Re: looking for a source to purchase taper locks

thank you Stewart i am all set now....thank you for the reply........Jim
Forum: Early V8 07-25-2012, 10:37 AM
Replies: 3
Views: 927
Posted By grinch
looking for a source to purchase taper locks

looking for a place to buy 3/4 ton ford taper locks that go in the axle shaft of a full floating rear.......the are the split pyramid looking piece that helps center the axle......i need...
Forum: Late V8 07-23-2012, 06:48 PM
Replies: 1
Views: 1,350
Posted By grinch
1950 mercury pressure plate # 10A7

Looking for a mercury pressure plate #10A7 for a core or a decent usable one. Lv message or call 978-356-4951. T/y. Jim
Forum: Early V8 (1932-53) 02-27-2012, 04:34 PM
Replies: 5
Views: 1,699
Posted By grinch
Re: i need a pic. of 46-48 clutch linkage.....pls

well that was fast.......it didn`t occur to me to try e-bay but that piece is exactly what i think i need.......thanks for pointing that out to me.....i will buy this and use it to do some...
Forum: Early V8 (1932-53) 02-27-2012, 01:32 PM
Replies: 5
Views: 1,699
Posted By grinch
i need a pic. of 46-48 clutch linkage.....pls

i wonder if anyone could post pictures of a 1946-48 ford clutch equalizer shaft i believe it has one end slotted at the bellhousing end and on the other end it is supported by a round ball and 2 half...
Forum: Early V8 01-30-2012, 05:00 PM
Replies: 6
Views: 5,279
Posted By grinch
Re: 1950 Mercury 8CM Flathead engine block, 4” crank and other parts.

hey folks.....got the parts i needed......am all set for now......thanks for replying...j/m
Forum: Early V8 01-27-2012, 08:48 PM
Replies: 0
Views: 1,032
Posted By grinch
1950 mercury pressure plate

need pressure plate from 1950 mercury......lv message etc....thanks
Forum: Early V8 01-27-2012, 04:47 PM
Replies: 6
Views: 5,279
Posted By grinch
Re: 1950 Mercury 8CM Flathead engine block, 4” crank and other parts.

am interested in flywheel clutch disc and pressure plate [email protected] or call 978-356-2226....thanks
Showing results 1 to 9 of 9

 
Forum Jump
Sponsored Links (Register now to hide all advertisements)


All times are GMT -5. The time now is 02:34 AM.