Forum: Model A (1928-31)
06-06-2024, 07:00 PM
|
Replies: 14
Views: 611
Re: White walls
I think they look good either way. I had whitewalls on mine when I bought it, but they were OLD tires. Nearly 100% tread but completely dry-rotted. I wanted another set of whitewalls but after seeing...
|
Forum: Model A (1928-31)
06-03-2024, 07:41 PM
|
Replies: 28
Views: 1,437
Re: I give up
Run the engine as low as you can where it runs smooth, take a can of starter fluid and give a quick spray where the intake meets the engine. If the RPMs change you've found your culprit.
|
Forum: Model A (1928-31)
06-03-2024, 11:45 AM
|
Replies: 24
Views: 1,100
|
Forum: Model A (1928-31)
06-03-2024, 10:27 AM
|
Replies: 24
Views: 1,100
|
Forum: Model A (1928-31)
06-01-2024, 12:00 PM
|
Replies: 24
Views: 1,100
|
Forum: Model A (1928-31)
06-01-2024, 10:21 AM
|
Replies: 24
Views: 1,100
|
Forum: Model A (1928-31)
05-31-2024, 07:13 PM
|
Replies: 24
Views: 1,100
|
Forum: Model A (1928-31)
05-28-2024, 10:29 AM
|
Replies: 2
Views: 322
|
Forum: Model A (1928-31)
05-28-2024, 10:15 AM
|
Replies: 23
Views: 1,909
|
Forum: Model A (1928-31)
05-27-2024, 10:08 AM
|
Replies: 20
Views: 1,553
Re: Gas Station
I rest the gas nozzle in the neck as high as it can sit and set the gas nozzle at the lowest notch. Flame arrestor screen taken out too. Pump always clicks off right about at the full mark on the gas...
|
Forum: Model A (1928-31)
05-26-2024, 01:06 PM
|
Replies: 18
Views: 732
Re: Leak on top of carb...
I see where it looks like its coming from the throttle shaft. It looks like its wet up above the throttle shaft, or is that just a shadow?
The only thing I could think would be fuel flowing out of...
|
Forum: Model A (1928-31)
05-21-2024, 02:45 PM
|
Replies: 21
Views: 1,006
|
Forum: Model A (1928-31)
05-19-2024, 12:41 PM
|
Replies: 10
Views: 605
Re: Aaaa
"the driver sat in the center of the cab and used one brake and one accelerator pedal, but shifted both transmissions independently with two different clutch pedals."
...
|
Forum: Model A (1928-31)
05-19-2024, 10:58 AM
|
Replies: 51
Views: 2,583
Re: sign of the times
I have a DSG in my other car. Anyone could get into a car with a DCT, put it in drive, and go. There's not much difference in operation, you might notice it's a little jerky until you get used to it....
|
Forum: Model A (1928-31)
05-18-2024, 01:06 PM
|
Replies: 51
Views: 2,583
Re: sign of the times
Unless the guy is missing a leg, there's no excuse. Anyone can learn to drive stick in an afternoon, it's not rocket science. I would think one of the qualifications of being a professional car mover...
|
Forum: Model A (1928-31)
05-12-2024, 12:16 PM
|
Replies: 19
Views: 1,360
Re: Removing stuck distributor and lower shaft
It soaked all night before I made this post in PB blaster. I used a propane torch to heat it up and more PB blaster and ever so gently used a pry bar on either end of the distributor. I repeated that...
|
Forum: Model A (1928-31)
05-11-2024, 08:06 PM
|
Replies: 10
Views: 546
|
Forum: Model A (1928-31)
05-11-2024, 04:49 PM
|
Replies: 10
Views: 546
|
Forum: Model A (1928-31)
05-11-2024, 12:09 PM
|
Replies: 10
Views: 546
|
Forum: Model A (1928-31)
05-11-2024, 11:37 AM
|
Replies: 12
Views: 618
Re: Tight crank gear
Contact whoever you bought it from and get them to replace it for you
Alternatively, take it down to your local shop and have them bore it to the size you're looking for
|
Forum: Model A (1928-31)
05-09-2024, 04:48 PM
|
Replies: 8
Views: 702
|
Forum: Model A (1928-31)
05-06-2024, 01:11 PM
|
Replies: 41
Views: 4,071
Re: Snyder's New Catalog Came...and a Warning!
If I was paying someone hourly labor to do all the work I've put into mine, I couldn't justify owning it. I'd probably be $20k to $30k deep in just labor costs. My car wasn't even in bad shape. Its...
|
Forum: Model A (1928-31)
05-03-2024, 08:45 PM
|
Replies: 41
Views: 4,071
Re: Snyder's New Catalog Came...and a Warning!
Speaking of hoarding parts, not Model A but Willys Jeep story...
When I was a kid my dad was into old Willys jeeps. We used to buy parts from this old man who had several acres of shipping...
|
Forum: Model A (1928-31)
05-03-2024, 11:36 AM
|
Replies: 19
Views: 1,360
|
Forum: Model A (1928-31)
05-03-2024, 10:12 AM
|
Replies: 19
Views: 1,360
Re: Removing stuck distributor and lower shaft
As far as it being that one piece shaft, I'm not sure. This is the first time I've opened up the engine. It is possible that it is the one piece shaft.
I can't bring myself to just leave it (as...
|