Forum: Early V8 (1932-53)
05-31-2014, 08:30 PM
|
Replies: 16
Views: 3,440
Re: miss ??
I would have never guessed that it was the f'n air filters. those little coragated cardboard filters. I cut out the paper and left in the screen mesh, until I get a good filter for it. ...
|
Forum: Early V8 (1932-53)
05-30-2014, 03:33 PM
|
Replies: 16
Views: 3,440
Re: miss ??
thanks G. M. i'm going out there now i'll post the out come.
|
Forum: Early V8 (1932-53)
05-30-2014, 02:20 PM
|
Replies: 16
Views: 3,440
Re: miss ??
well i'm pulling my hair out again. I can't find this miss. its there at all exceleration. coil rebuilt and distribuator set-up 500 miles ago by Skip in Fla. changed the condenser plugs are good. ...
|
Forum: Early V8 (1932-53)
05-22-2014, 05:59 PM
|
Replies: 16
Views: 3,440
Re: miss ??
well I installed the condenser and ballast res. I got from Mac's. it wasn't any of those. It still has the slight miss just sitting when I take the throttle up to around 1 thous. rpm. I can hear the...
|
Forum: Early V8 (1932-53)
05-20-2014, 04:41 PM
|
Replies: 16
Views: 3,440
Re: miss ??
Mike, its the stock 6 volt, 4d, I ordered a condenser from Mac's i'll get it tomarow. I also got a new ballast res. Ido hope it all works out for me.
|
Forum: Early V8 (1932-53)
05-19-2014, 07:36 PM
|
Replies: 45
Views: 11,147
|
Forum: Early V8 (1932-53)
05-19-2014, 05:31 PM
|
Replies: 16
Views: 3,440
Re: miss ??
so I guess i'll change out the ballast resister too, I do know before I had a ballast resister on it would act somewhat like its doing know, but not as bad. I don't know if they go bad or not so i'll...
|
Forum: Early V8 (1932-53)
05-19-2014, 01:34 PM
|
Replies: 16
Views: 3,440
Re: miss ??
I know I put a new condenser on 3 years ago when I had Skip Haney re build my coil. is there anyway I can test the condenser?
|
Forum: Early V8 (1932-53)
05-19-2014, 07:49 AM
|
Replies: 16
Views: 3,440
miss ??
so we were coming home from a cruze Saturday, and my '38 flathead started to miss. it seams like an electrical miss. a guy told me I could check an electrical miss by a jump wire from my coil to the...
|
Forum: Early V8 (1932-53)
04-09-2014, 03:35 PM
|
Replies: 6
Views: 1,656
Re: stromberg large 97 help
thanks Charlie, it was the float the bowl was full and the float sank,.Max is sending me a new one and a horn gasket.Charlie do I have to readjust the new float, or can Max do that before he sends...
|
Forum: Early V8 (1932-53)
04-09-2014, 01:53 PM
|
Replies: 6
Views: 1,656
Re: stromberg large 97 help
well it wasn't the needle and seat, put the carb back on and fuel over filling the rear carb. any ideas welcome??
|
Forum: Early V8 (1932-53)
04-09-2014, 11:10 AM
|
Replies: 6
Views: 1,656
stromberg large 97 help
got two new 97's two years ago from one of the best. well today I went to start the car for the first time this year. the rear carb was pouring out gas, I took it off I believe the only thing to look...
|
Forum: Early V8 (1932-53)
12-16-2013, 08:31 PM
|
Replies: 12
Views: 3,535
|
Forum: Early V8 (1932-53)
12-16-2013, 05:34 PM
|
Replies: 12
Views: 3,535
|
Forum: Early V8 (1932-53)
12-16-2013, 04:27 PM
|
Replies: 12
Views: 3,535
Re: 1934 v8 grill emblem
yes it is, but the question is, is there any way to tell if its original? do repos have the part # on them?
|
Forum: Early V8 (1932-53)
12-16-2013, 04:13 PM
|
Replies: 12
Views: 3,535
|
Forum: Early V8 (1932-53)
12-16-2013, 03:52 PM
|
Replies: 12
Views: 3,535
|
Forum: Early V8 (1932-53)
12-16-2013, 12:36 PM
|
Replies: 12
Views: 3,535
1934 v8 grill emblem
I have one, and it looks original,, is there a way I can tell?? #'s on back 40-8221 is this the original #'s any way I can tell?
|
Forum: Early V8 (1932-53)
12-09-2013, 12:02 PM
|
Replies: 1
Views: 1,337
'33 + '34 grill emblem
I would like to know if the '33 + '34 had the same front grill emblem? a two piece one.:)
|
Forum: Early V8 (1932-53)
11-08-2013, 10:24 PM
|
Replies: 6
Views: 2,128
|
Forum: Early V8 (1932-53)
11-07-2013, 06:15 PM
|
Replies: 6
Views: 2,128
Re: early Ford emblem I.D.
do the oval ford emblems go with the V8 emblems on the truck? i'm not sure what rack your talking about.
|
Forum: Early V8 (1932-53)
11-07-2013, 05:13 PM
|
Replies: 6
Views: 2,128
early Ford emblem I.D.
I was cleaning out and old garage of a guy that attends car cruses that I go to. and he said I could take what I want. I found these emblems in the back of a cabnit. he believes them to be '33 or '34...
|
Forum: Early V8 (1932-53)
11-03-2013, 05:27 PM
|
Replies: 3
Views: 1,440
Re: wide 5 hubcaps 1936-1939
thanks Kube, I got original ones then. because theres a dent on the inside, but its not on the outside where the stainless V8 is. and I can feel the ridge on the V8 stainless were it goes on the...
|
Forum: Early V8 (1932-53)
11-03-2013, 05:04 PM
|
Replies: 3
Views: 1,440
wide 5 hubcaps 1936-1939
I know they are two piece. I got a set that from the inside there one piece. on the outside I feel a lip with my finger nail and I can see it looks like it snaps on. my question is, is the whole cap...
|
Forum: Model A (1928-31)
10-25-2013, 04:29 PM
|
Replies: 0
Views: 1,171
'31 latchs+strike plates.
I just installed my new latchs and strike plates, well I have the strike all the way front. which doesn't really matter, but why have the adjustment it would never latch if it was back any. next I...
|