Forum: Model A (1928-31)
03-23-2022, 01:17 PM
|
Replies: 11
Views: 1,759
Re: Engine pans
They will not surpress engine,chassis or road noise. They will add anadditional point of ground to the electrical system.
To decrease engine and road noise you may want to insulate the interior...
|
Forum: Model A (1928-31)
02-17-2022, 09:51 PM
|
Replies: 8
Views: 1,441
|
Forum: Model A (1928-31)
02-04-2022, 09:52 PM
|
Replies: 25
Views: 3,291
|
Forum: Model A (1928-31)
11-13-2021, 08:14 PM
|
Replies: 19
Views: 2,865
Re: Changing coolant for the winter
I use
Prestone® Platinum All Vehicles
Antifreeze + CoolantConcentrate in all my cars. Only have to change it every Fifteen years and it is good for 350,000 miles I run it summer and winter in my...
|
Forum: Model A (1928-31)
04-05-2021, 08:45 PM
|
Replies: 8
Views: 1,487
|
Forum: Model A (1928-31)
03-29-2021, 07:39 PM
|
Replies: 8
Views: 1,417
|
Forum: Model A (1928-31)
03-18-2021, 02:07 PM
|
Replies: 5
Views: 1,209
Re: 1930 roadster hood latches
You did not state what year car you are working on. The 28-29 latches are different from the 30-31 When ordering you must specify what year your car is.
|
Forum: Model A (1928-31)
03-18-2021, 01:29 PM
|
Replies: 19
Views: 1,895
|
Forum: Model A (1928-31)
03-14-2021, 08:52 PM
|
Replies: 10
Views: 1,703
|
Forum: Model A (1928-31)
03-09-2021, 06:48 PM
|
Replies: 3
Views: 1,584
What was Henry thinking ?
I am attempting to install a rear window frame and glass in a 1930 Closed Cab Pick-up truck.
I installed the rubber gasket around the window glass and all went fine. No puckered corners. ...
|
Forum: Model A (1928-31)
03-08-2021, 04:16 PM
|
Replies: 25
Views: 4,027
Re: Oil Leak Troubleshooting
The large FIBER washers go inside each end of the oil return pipe. The small copper washers go betweem the mounting bolts anon the OUTSIDE of the return pipe.Sealant only needed on the large fiber...
|
Forum: Model A (1928-31)
03-07-2021, 09:39 PM
|
Replies: 11
Views: 1,704
Re: Pan Gasket
Have you determined where the leak is coming from? Is it the pan gasket or possibly the front or rear crankshaft seal ? If it's the pan gasket I only apply gasket sealer to the block side of the...
|
Forum: Model A (1928-31)
03-07-2021, 09:24 PM
|
Replies: 56
Views: 7,465
Re: Changing of the Guard
The future "Guard" is really in for a big change what with tree huggers proposing things such as :
A California city just banned all new gas stations in zero-emissions push.
The City of Petaluma...
|
Forum: Model A (1928-31)
03-05-2021, 11:42 AM
|
Replies: 57
Views: 13,125
Re: What is Engine 'Break-in'??
"The (mis)use of gasket sealers (Copper Kote, et/al) often hinders the thermal expansion & contraction of the gasket which will affect fastener torque ratings being met."
Brent, are you saying not...
|
Forum: Model A (1928-31)
03-04-2021, 01:46 PM
|
Replies: 10
Views: 1,297
Re: Inspecting generator field coils
Why not take it to the experienced generator shop and have the coils tested. If OK use them. If not,then replace them and install new brushes and bearings.
|
Forum: Model A (1928-31)
03-02-2021, 03:48 PM
|
Replies: 50
Views: 9,014
|
Forum: Model A (1928-31)
03-02-2021, 01:35 PM
|
Replies: 19
Views: 1,696
|
Forum: Model A (1928-31)
02-14-2021, 01:32 PM
|
Replies: 21
Views: 3,119
|
Forum: Model A (1928-31)
02-11-2021, 09:27 PM
|
Replies: 16
Views: 2,236
Re: Rolling chassis
If you can find a rolling or better yet a running chassis that is in good condition you would save a LOT of time and money compared to putting one together piece by piece.
|
Forum: Model A (1928-31)
01-30-2021, 01:17 PM
|
Replies: 7
Views: 1,830
Re: Model A Rearend
Read Tom Endy's rear end rebuid seminar.
Follow this link....http://www.santaanitaas.org/wp-content/uploads/2014/08/Differential-Rear-End-Restoration-Revised-2014.pdf
|
Forum: Model A (1928-31)
01-26-2021, 10:06 PM
|
Replies: 28
Views: 3,907
Re: Does Gauge of Ground Wire Matter
This is a solid copper ground strap originally used on Model A Fords.
The originals were covered with solder to prevent corrosion.
This strap is available at Brattons Model A Supply as well as...
|
Forum: Model A (1928-31)
11-03-2020, 08:45 PM
|
Replies: 5
Views: 1,281
|
Forum: Model A (1928-31)
10-26-2020, 02:10 PM
|
Replies: 26
Views: 5,166
|
Forum: Model A (1928-31)
10-26-2020, 12:39 PM
|
Replies: 24
Views: 5,275
Re: Snyder 5.5 head
So in the name of safety,due to faster road traffic, the judging committe should overlook the cosmetic difference of the slightly shorter cylinder head.
|
Forum: Model A (1928-31)
10-12-2020, 01:51 PM
|
Replies: 3
Views: 1,017
|