Forum: Early V8 (1932-53)
Yesterday, 05:21 AM
|
Replies: 22
Views: 703
|
Forum: The Test Forum
Yesterday, 05:20 AM
|
Replies: 89
Views: 21,937
|
Forum: Early V8 (1932-53)
05-21-2024, 11:23 AM
|
Replies: 3
Views: 201
Re: O2 bung question
IMPORTANT INSTALLATION NOTE - UEGO Sensor Mounting Orientation
A weld-in M18 X 1.5 boss is supplied for sensor installation. Mount the O2 sensor in the
exhaust system at least 18 inches downstream...
|
Forum: The Test Forum
05-21-2024, 11:22 AM
|
Replies: 89
Views: 21,937
|
Forum: Early V8 (1932-53)
05-20-2024, 09:30 AM
|
Replies: 7
Views: 466
Re: Bump steer
Yes, many copy cats following awful setups. Good article here:
https://www.motortrend.com/how-to/solid-axle-front-suspension-details/
|
Forum: Early V8 (1932-53)
05-19-2024, 03:59 PM
|
Replies: 2
Views: 285
Re: Setting Ignition Points - 59AB
Yes, but that is for setting the timing with the two scales. Good post like Van Pelt has on his site. I'm after a reasonable way to get as accurate as I can for the gaps and dwell.
Thanks.\,...
|
Forum: Early V8 (1932-53)
05-19-2024, 09:51 AM
|
Replies: 2
Views: 285
Setting Ignition Points - 59AB
Hi,
I got lost on the internet yesterday and this morning looking for a DIY precise way of setting ignition points.
First, I found a great video from Mart,...
|
Forum: Early V8 (1932-53)
05-17-2024, 03:43 PM
|
Replies: 53
Views: 2,325
Re: Hot rod steering box
I don't understand why you are against an F-1 box.
Regarding the Hudson 1939 with a longer shaft than the '37 another ??
NealinCA posts on the HAMB, not here.
3" chop is too much. Any dip in...
|
Forum: Early V8 (1932-53)
05-16-2024, 09:53 AM
|
Replies: 5
Views: 191
|
Forum: Early V8 (1932-53)
05-16-2024, 08:57 AM
|
Replies: 5
Views: 191
Re: Automotive switch ratings?
Thanks Tubman
I used a lower voltage due to the drop when I'm starting up with the foot mounted starter switch, no solenoid.
Even so 13.6v X 6a = 81.6 watts
a question of the ratings,...
|
Forum: Early V8 (1932-53)
05-16-2024, 08:36 AM
|
Replies: 5
Views: 191
Automotive switch ratings?
I had a running and starting issue this week so I'm replacing my Petronix II with a Bob Drake rebuilt 1942 crab distributor on my 59AB. I'm planning to add a ceramic 1.5 ohm inline with the coil's...
|
Forum: Early V8 (1932-53)
05-15-2024, 02:56 PM
|
Replies: 36
Views: 1,562
Re: Oil leak
You may be able to pull the pan by rotating the motor. Either #1 or#5 rod bearing caps may be causing the hangup.
Firing order is 1-5-4-8-6-3-7-2
|
Forum: Early V8 (1932-53)
05-13-2024, 12:55 PM
|
Replies: 53
Views: 2,325
Re: Hot rod steering box
For a Left Hand Drive, LHD; turning the steering wheel CW rotates the Pitman arm CCW which pulls the drag link forward, turning the wheels to the right.
|
Forum: Early V8 (1932-53)
05-13-2024, 11:52 AM
|
Replies: 53
Views: 2,325
Re: Hot rod steering box
https://www.jalopyjournal.com/forum/threads/tech-32-rpu-project-roadster-izing-a-50-cab-in-3-simple-steps.299603/page-2#post-3185444
Many posts by NEALINCA on the HAMB
|
Forum: Early V8 (1932-53)
05-13-2024, 09:58 AM
|
Replies: 53
Views: 2,325
Re: Hot rod steering box
Wise words from Tim!
Use a modified F1 or one of Neal's new boxes.
Space is tight so avoid the F100.
Glenn
|
Forum: Early V8 (1932-53)
05-11-2024, 03:41 PM
|
Replies: 36
Views: 1,562
Re: Oil leak
From page #61 through #66 of the Techno Source ... below
"Rear Crankshaft Sealing
From 1932 to sometime in 1941, Ford used a non-contacting crankshaft thin flange that whipped oil into block...
|
Forum: Early V8 (1932-53)
05-11-2024, 06:42 AM
|
Replies: 7
Views: 464
Re: 2 overdrives
Hi Fred,
The coupler to spline is sealed. I used RTV. I also added a vent to the left side axle housing per the instructions. Good picture is from 19Fordy
...
|
Forum: Early V8 (1932-53)
05-10-2024, 12:28 PM
|
Replies: 53
Views: 2,325
|
Forum: Early V8 (1932-53)
05-10-2024, 07:36 AM
|
Replies: 7
Views: 464
Re: 2 overdrives
I installed one a couple of years ago at the same time I replaced my Columbia clutches.
https://www.fordbarn.com/forum/attachment.php?attachmentid=542370&d=1715344413...
|
Forum: The Test Forum
05-10-2024, 07:34 AM
|
Replies: 89
Views: 21,937
|
Forum: Early V8 (1932-53)
05-09-2024, 02:16 PM
|
Replies: 4
Views: 307
|
Forum: Early V8 (1932-53)
05-09-2024, 02:07 PM
|
Replies: 53
Views: 2,325
Re: Hot rod steering box
1932 original ratio is 13:1.
Early '33s also had 13:1 but were then changed to 15:1 for the balance of the '33s and '34s. The 15:1 worm and sector pair fit perfectly in the '32 boxes.
The Hudson...
|
Forum: Early V8 (1932-53)
05-08-2024, 10:30 AM
|
Replies: 5
Views: 421
Re: Bolting Down A 32 Sedan Body
Note that rear frame reinforcement was provided early on to deal with the sagging. DavidG's post and the balance of the same thread discuss it.
...
|
Forum: Early V8 (1932-53)
05-08-2024, 10:20 AM
|
Replies: 18
Views: 795
|
Forum: Early V8 (1932-53)
05-08-2024, 07:37 AM
|
Replies: 13
Views: 486
Re: Another spongy brake pedal
Yes with a dual reservoir system, you could do the left front first and for the rear whichever line is longest.
I'd block the brake pedal to mimic brake application, leave it for a few hours or...
|