Go Back   The Ford Barn > Search Forums
Reload this Page Search Results

Sponsored Links (Register now to hide all advertisements)

Page 1 of 13 1 234511 Last »
Showing results 1 to 25 of 302
Search took 0.02 seconds. Search: Posts Made By: Graham Freeman
Forum: Early V8 (1932-53) Today, 02:24 AM
Replies: 0
Views: 9
Posted By Graham Freeman
1932-1934 running boards

I have heard that 1932 & 1933/34 running boards are no longer being reproduced and not likely to be again.
Any truth in this rumor?
Graham
Forum: Early V8 Today, 02:17 AM
Replies: 0
Views: 8
Posted By Graham Freeman
1932-1934 running boards

I have heard that 1932 & 1933/34 repro running boards are no longer being produced and not likely to be made again.
Any truth in this?
Graham
Forum: Early V8 (1932-53) 05-18-2024, 07:18 PM
Replies: 14
Views: 758
Posted By Graham Freeman
Re: 1932/36 Condenser replacement.

Thanks guys.
I think i shall go with the 3rd Gen option as have found them very good to deal with from here in NZ.
Forum: Early V8 (1932-53) 05-18-2024, 04:25 AM
Replies: 14
Views: 758
Posted By Graham Freeman
1932/36 Condenser replacement.

My 1934 Cabriolet motor decided to go into don't want to start mode today.
It was traced to an electrical problem.
I am running a rebuilt NOS distributor with a Skip Haney rebuilt 3 screw coil (6...
Forum: Early V8 (1932-53) 04-15-2024, 09:58 PM
Replies: 50
Views: 2,232
Posted By Graham Freeman
Re: 91 birthday today

Happy birthday Ron.
I always enjoy reading your posts here in NZ.
Forum: Early V8 (1932-53) 02-20-2024, 03:30 AM
Replies: 9
Views: 525
Posted By Graham Freeman
Re: 1936 ford series 68-radio antenna-please help!

I had a similar problem with an antenna for my 1934 cabriolet.
Originally there were 2 options, spare wheel or under the running board.
I decided on another way that has proved very successful.
I...
Forum: Early V8 (1932-53) 01-10-2024, 05:52 PM
Replies: 6
Views: 727
Posted By Graham Freeman
Re: Cabriolet stainless steel window frames question.

Well tackled the repair finally today.
I was able to get the glass out ok without breaking it and replaced it in the new frame.
The corner tab I was concerned about came off real easy and went back...
Forum: Early V8 (1932-53) 01-10-2024, 05:47 PM
Replies: 6
Views: 829
Posted By Graham Freeman
Re: 1934 cabriolet interior door mechanisms.

Bump
Forum: Early V8 (1932-53) 12-28-2023, 03:46 AM
Replies: 10
Views: 905
Posted By Graham Freeman
Re: Jackson MI swap meet

This reminds me a bit about a swap meet here in New Zealand that I went to many years ago.
Got up real early, drove 200 miles, and were the first people there.
Turns out we were actually 50 weeks...
Forum: Early V8 (1932-53) 12-24-2023, 02:17 AM
Replies: 6
Views: 727
Posted By Graham Freeman
Re: Cabriolet stainless steel window frames question.

Thanks Kurt that was the answer I was hoping for before attempting and causing damage.
I was worried that they may have been soldered on or similar.
Graham
Forum: Early V8 (1932-53) 12-23-2023, 07:15 PM
Replies: 6
Views: 727
Posted By Graham Freeman
Re: Cabriolet stainless steel window frames question.

Still seeking help.
Thankyou
Forum: Early V8 (1932-53) 12-16-2023, 03:21 PM
Replies: 6
Views: 727
Posted By Graham Freeman
Cabriolet stainless steel window frames question.

I have a slightly damaged (worn thru the stainless in an area due to rubbing on steel frame when being wound up) plus other imperfections. I have another to replace this with for my 34 cabriolet but...
Forum: Early V8 (1932-53) 12-05-2023, 04:43 AM
Replies: 20
Views: 1,702
Posted By Graham Freeman
Re: Anyone know if a NOS remanufactured distributor is a bolt on

I had a NOS 34 distributor.
Grease had dried up so had it all stripped and cleaned up.
Had it set up properly with a NOS coil with Skip's internals and no problems whatsoever.
Forum: Early V8 (1932-53) 11-09-2023, 02:34 AM
Replies: 18
Views: 1,856
Posted By Graham Freeman
Re: Passing of Nick Cassaro

Sad to hear that.
Nick helped me out several times during the restoration of my 1934 Cabriolet.
Was a great help.
RIP Nick.
Forum: Early V8 (1932-53) 09-16-2023, 03:00 AM
Replies: 28
Views: 1,543
Posted By Graham Freeman
Re: Ford 1933

Both sides the same.
Forum: Early V8 (1932-53) 07-31-2023, 03:44 AM
Replies: 34
Views: 1,335
Posted By Graham Freeman
Re: woodgrained window-moulding screws?

I have always found that pushing/pulling down on the area where the screw goes in thru the moulding while tightening the screw reduces any damage.
Forum: Early V8 (1932-53) 07-02-2023, 06:42 PM
Replies: 26
Views: 3,171
Posted By Graham Freeman
Re: 32-34 Tie Rod End Adjustment

The basic tool I made above will fit between the backing plate and the end of the tie rod enabling adjustment to be made.
Forum: Early V8 (1932-53) 07-01-2023, 11:15 PM
Replies: 26
Views: 3,171
Posted By Graham Freeman
Re: 32-34 Tie Rod End Adjustment

It took me 10min to make this tool out of a bit of 1 inch scrap flat bar 30 years ago.
Still works fine.519768

519769

519770
Forum: Early V8 06-30-2023, 05:55 AM
Replies: 3
Views: 567
Posted By Graham Freeman
Re: V8 Times Early 1966/68 issues for sale

Still have some
Forum: Early V8 06-23-2023, 11:00 PM
Replies: 3
Views: 567
Posted By Graham Freeman
Re: V8 Times Early 1966/68 issues for sale

still have some
Forum: Early V8 06-19-2023, 11:41 PM
Replies: 3
Views: 567
Posted By Graham Freeman
Re: V8 Times Early 1966/68 issues for sale

Still have some.
Forum: Early V8 06-15-2023, 10:19 PM
Replies: 3
Views: 567
Posted By Graham Freeman
V8 Times Early 1966/68 issues for sale

I have finally after many years been able to put together a complete original set of V8 Times From Vol 1/1 thru to present.
Naturally I did accumulate additional early copies that I do not require....
Forum: Early V8 06-04-2023, 08:59 PM
Replies: 1
Views: 468
Posted By Graham Freeman
Re: 1934 ashtray radio speaker box parts.

Still looking thanks.
Forum: Early V8 (1932-53) 06-04-2023, 04:36 AM
Replies: 4
Views: 622
Posted By Graham Freeman
Re: 1934 ashtray radio speaker box parts.

Still looking thanks
Forum: Early V8 (1932-53) 05-31-2023, 10:39 PM
Replies: 4
Views: 622
Posted By Graham Freeman
Re: 1934 ashtray radio speaker box parts.

Thanks for that.
I have emailed him.
Graham
Showing results 1 to 25 of 302
Page 1 of 13 1 234511 Last »

 
Forum Jump
Sponsored Links (Register now to hide all advertisements)


All times are GMT -5. The time now is 03:26 AM.