Forum: Model-A
09-10-2023, 09:07 PM
|
Replies: 0
Views: 427
original front seats
Pair of original front "bucket" seats for Model A Tudor. Upholstery in excellent condition but not original. $75 for pair plus UPS charges. [email protected] San Diego, CA
|
Forum: Model A (1928-31)
08-03-2023, 10:41 PM
|
Replies: 10
Views: 1,909
Burtz engine oil pump
According to Burtz engine Builders Guide---- A stock Model A oil pump with close fitting gears has been found to provide more than adequate volume and a relief valve is needed etc. Has anyone tried...
|
Forum: Model-A
03-08-2023, 10:38 AM
|
Replies: 0
Views: 442
Victoria rear window shade
Need an original rear window shade roller for Victoria, 26 inches long. Also rear assist straps used to assist when you exit the rear seat area. Thanks Arlyn Bieber
|
Forum: Model-A
02-22-2023, 09:36 PM
|
Replies: 0
Views: 589
|
Forum: Model-A
02-10-2023, 12:58 AM
|
Replies: 0
Views: 703
|
Forum: Model-A
10-28-2022, 08:56 PM
|
Replies: 0
Views: 427
Right side spare tire plate
Looking for an original right side spare tire plate used to hold the spare tire in the fender. An original will have a "R" stamped in the plate. anbieb@ san.rr.com
|
Forum: Model A (1928-31)
05-16-2022, 08:52 AM
|
Replies: 15
Views: 2,215
Re: Rear Main Thrust Face
Larry is right. I have built more babbit engines than I can remember. Anything you do is a band aid at this point. The engine babbit is worn out, Do it right and replace the babbit, machine and...
|
Forum: Model A (1928-31)
12-26-2021, 11:44 AM
|
Replies: 8
Views: 1,346
|
Forum: Model A (1928-31)
08-08-2021, 03:23 PM
|
Replies: 47
Views: 5,220
Re: Do I panic? - Rear main oil leak.
Is it leaking a 1" puddle or a 6" puddle? If a 1" puddle, that is normal. If a 6"puddle and it happened suddenly and is coming from the rear of the engine, the rear main babbit bearing has probably...
|
Forum: Model-A
05-30-2021, 05:05 PM
|
Replies: 0
Views: 580
|
Forum: Model-A
04-21-2021, 09:14 PM
|
Replies: 0
Views: 565
30-31 Coupe wooden header
Need a new 30-31 wood header (above windshield). Checked all the suppliers and none are available until June. Arlyn Bieber
|
Forum: Model A (1928-31)
03-04-2021, 10:27 AM
|
Replies: 12
Views: 2,528
|
Forum: Model A (1928-31)
12-01-2020, 07:49 AM
|
Replies: 20
Views: 5,636
Re: Front End Rebuild Questions
Don't forget to straighten the axle, it is the foundation for all the other work you are doing. It has been my experience after rebuilding over 100 front ends that 99% of the axles are bent. I also...
|
Forum: Model-A
10-15-2020, 09:58 PM
|
Replies: 0
Views: 782
AA speedometer driven gear needed
Need to purchase a good condition AA speedometer driven gear Part # AA17271-F (6.6-11). The AA truck is an early 1930 short bed. The gear has 17 teeth and is slotted for the oval speedometer cable....
|
Forum: Model A (1928-31)
02-02-2020, 04:10 PM
|
Replies: 11
Views: 2,358
Re: two Ford assembly plants...
I would pick KC because it is likely my 1930 Coupe was "born" there. I was born in Kansas and rode home from the hospital in that very same Coupe in 1939. That Coupe resides in my garage and is in...
|
Forum: Early V8
01-02-2020, 10:45 AM
|
Replies: 0
Views: 886
|
Forum: Model A (1928-31)
04-13-2019, 05:33 PM
|
Replies: 1
Views: 1,170
Starter drive shaft end play
Anyone know the Ford specification for starter shaft end play? Just received a rebuilt starter and the end play is 0.120" or nearly 1/8". Seems like a lot to me. Snyder's list two thrust washer...
|
Forum: Model A (1928-31)
04-11-2019, 09:05 PM
|
Replies: 12
Views: 2,063
Water leak in cylinder
Have an Model A engine that developed a pin hole half way down number 3 cylinder. Bored the cylinder and installed a sleeve thinking that would stop the water leak but now when I air test the water...
|
Forum: Model-A
03-30-2019, 03:24 PM
|
Replies: 0
Views: 507
|
Forum: Model-A
03-30-2019, 03:17 PM
|
Replies: 0
Views: 513
|
Forum: Model A (1928-31)
03-18-2019, 11:04 PM
|
Replies: 10
Views: 1,870
Re: Wheel Balance with Dyna Beads
The easy way to install the beads is with an ice pick punch a hole in the tube then insert the beads and patch the hole. Of course you have to remove the tire and tube. Another way is to install...
|
Forum: Model-A
03-17-2019, 09:34 PM
|
Replies: 0
Views: 802
Original Model A Intruction Books
1. Original late '31 instruction book, mint condition $125
2. Original inst. book center E. brake (squeeze grip) good condition $30
3. Original inst. book center E. brake (squeeze grip) fair...
|
Forum: Model-A
03-17-2019, 09:00 PM
|
Replies: 0
Views: 706
Original Model A window curtain rollers
Original window curtain rollers for rear and side windows.
1. Original window curtain roller 26 1/2" long with new Brown silk w/ tab, criss-cross pattern per Judging Standards $125
2. Original...
|
Forum: Model A (1928-31)
02-14-2019, 11:00 AM
|
Replies: 29
Views: 4,241
Re: Stearing sector problems
Unless I am restoring for 500 points I would never attempt to restore a 7 tooth box. Been down that road!!!! Henry changed to a 2 tooth for a reason. I suggest you do the same. Forget trying to...
|
Forum: Model A (1928-31)
01-05-2019, 07:16 PM
|
Replies: 2
Views: 1,720
Enclosed 30' trailer
Anyone know of an enclosed 30' trailer in Southern CA that could be rented to transport 2 Model As from San Diego to the MARC National Meet next August. Thanks Arlyn Bieber, [email protected]
|