Dual carbs
 

Stupid question.
How do you get the back bolt out? Is there a special wrench or what have others done??
Paul in CT


It's the front carb on an Almquist manifold.

Re: Dual carbs
 

Paul:

Which back bolt are you referring to? The one center mounting stud under the carb? If so, just a box wrench will do the job.

Re: Dual carbs
 

Photo please of your carbs/intake.

Re: Dual carbs
 

You're probably trying to avoid taking off both carbs to get to the one nut. I have the same scenario. There's just no avoiding it.

Re: Dual carbs
 

On Stromberg's it easier to just remove the three screws hold the bodies to the base. Thus leaving the throttle plate base on the intake. Now if you need to remove the base you can easily get to the mounting hardware.
Ronnieroadster

Re: Dual carbs
 

Thanks Ron, I'll try that.
Paul