Threaded 'VS' welded steering arm balls I have a pair of 32 spindles with out balls on them, and the holes at the end of the arms are tapered for a threaded ball - much the same as a typical,
but later tie rod end. Does anyone know where I can locate "threaded" ball studs for these? I looked at Brattons and Snyders, but all they list in their catalogs are the welded in studs. Thanks, Steve |
Re: Threaded 'VS' welded steering arm balls Macs
|
Re: Threaded 'VS' welded steering arm balls I got NOS ones from Fred at Southside Obsolete. http://www.southsideobsolete.com/Sou...e/Welcome.html
He goes by Barnfind08 on the early V8 forum. I read that the taper on some of the new ones are not correct. |
Re: Threaded 'VS' welded steering arm balls Hello Steve,
I was in the same boat until I found a pair of spindles that looked like new, searched-high low and found them at CW Ford, Orange County Ca. (800) 322-1932. I just ordered a pair, dont forget to order the nuts if you dont have any. Have a nice day Brian. |
Re: Threaded 'VS' welded steering arm balls Thanks for all the suggestions, and I'll start calling them tomorrow.
|
Re: Threaded 'VS' welded steering arm balls Heck, forgot all about California being 2 hours behind us back here - just ordered the parts I needed and they're on the way!
Thanks for the help. |
Re: Threaded 'VS' welded steering arm balls The taper problem was fixed long ago I gather. The Macs ones are USA made and the correct iron oxide finish and hopefully hardened.
I've got 32 guts in my RHD two tooth. |
All times are GMT -5. The time now is 09:36 AM. |
Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2024, vBulletin Solutions Inc.