The Ford Barn - Helmet Distributor on the HAMB

The Ford Barn (https://www.fordbarn.com/forum/index.php)

- Early V8 (1932-53) (https://www.fordbarn.com/forum/forumdisplay.php?f=4)

- - Helmet Distributor on the HAMB (https://www.fordbarn.com/forum/showthread.php?t=282116)

Hoop	06-05-2020 08:31 AM

Helmet Distributor on the HAMB

Thought this was interesting.

https://www.jalopyjournal.com/forum/...eeded.1195035/

35fordtn

06-05-2020 08:50 AM

Re: Helmet Distributor on the HAMB

Those are very clearly Dennis carpenter points

Sent from my iPhone using Tapatalk

Will D

06-05-2020 01:39 PM

Re: Helmet Distributor on the HAMB

3 Attachment(s)

Had a similar issue with some points I got awhile back from standard. They did not align even after bending back to 90...had to add a spacer below the point block, then sand the top of the block to allow brass washer and c-pin to fit back in while allowing the block to pivot freely. Had more time than money...

https://www.fordbarn.com/forum/attac...1&d=1591382028

https://www.fordbarn.com/forum/attac...1&d=1591382031

All times are GMT -5. The time now is 08:37 PM.