|
Sponsored Links (Register now to hide all advertisements) |
|
|
Thread Tools | Display Modes |
08-17-2023, 02:56 PM | #1 |
Senior Member
Join Date: May 2010
Location: Washington Cty., ME or Flagler Cty., FL
Posts: 1,117
|
Rear Axle Rebuild
On page 47 of Tom Endy's 2014 paper there is reference to adjusting the backlash between the pinion and the ring gear. It is stated that the backlash may be between 0.010 and 0.020. Is this measured on the circumference of the drive shaft? Therefore, the amount of back and forth rotation of the drive shaft?
Ed |
08-17-2023, 06:46 PM | #2 |
Senior Member
Join Date: Jun 2015
Location: Red Deer, Alberta
Posts: 5,079
|
Re: Rear Axle Rebuild
Sponsored Links (Register now to hide all advertisements)
__________________
If you don't hear a rumor by 10 AM, start one!. Got my education out behind the barn! |
Sponsored Links (Register now to hide all advertisements) |
|
|
|
Sponsored Links (Register now to hide all advertisements) |
|