|
Sponsored Links (Register now to hide all advertisements) |
|
![]() |
![]() |
Thread Tools | Display Modes |
![]() |
#1 |
Senior Member
Join Date: May 2010
Location: Langhorne, PA.
Posts: 366
|
![]() City:
Langhorne
State:
PA
Found one.
Thanks....Mark Last edited by Mark T; 10-11-2013 at 01:24 PM. |
![]() |
![]() |
![]() |
#2 |
Senior Member
Join Date: May 2010
Posts: 124
|
![]()
Whats the difference from a 56 with a 4 spd.
|
![]() |
![]() |
Sponsored Links (Register now to hide all advertisements) |
|
![]() |
#3 |
Senior Member
Join Date: May 2010
Location: Langhorne, PA.
Posts: 366
|
![]() |
![]() |
![]() |
![]() |
#4 |
Member
Join Date: Nov 2012
Posts: 55
|
![]()
I have a Y block bell and a 3sp. truck trans, also 3sp car trans. let me see what the bell bolt pattern will fit, it may be a few days before I unload my trailer, just got home from a 3 day show/swap meet, everthing is still packed, and i'm tired. I will check and let you know. Ken in Va.
|
![]() |
![]() |
![]() |
#5 |
Member
Join Date: Nov 2012
Posts: 55
|
![]()
I did measure the bell tonight and I have a car bell, much smaller bolt pattern than a truck. The truck is 8-1/2 top and bottom, 7-1/4 both sides. car is 7-1/4 both sides but 5-1/4 top and 6-1/4 bottom all measurements are center to center on the bolt holes. This may help other's that are looking at bell housings.
|
![]() |
![]() |
![]() |
#6 |
Senior Member
Join Date: Jan 2012
Location: Montana
Posts: 3,658
|
![]() Sponsored Links (Register now to hide all advertisements)
|
![]() |
![]() |
![]() |
#7 |
Senior Member
Join Date: May 2010
Posts: 199
|
![]()
i have one too.25.00 plus shipping
|
![]() |
![]() |
![]() |
#8 |
Junior Member
Join Date: May 2010
Location: Walhalla, SC
Posts: 7
|
![]() |
![]() |
![]() |
![]() |
#9 |
Junior Member
Join Date: Dec 2012
Location: Rehoboth, Ma
Posts: 5
|
![]()
Hi, I need a car bell?? Thx, Tom
|
![]() |
![]() |
![]() |
|
|
Sponsored Links (Register now to hide all advertisements) |
|