|
Sponsored Links (Register now to hide all advertisements) |
|
![]() |
![]() |
Thread Tools | Display Modes |
![]() |
#1 |
Senior Member
Join Date: May 2010
Location: Gardiner Me.
Posts: 4,200
|
![]()
Where can I get one of those restricked fittings that goes into the side of the oil filter 49-8ba, this one is broken. 1/8 pipe into the can and take the flared 1/4 line fitting. Does anyone have a Dorman no? Thanks Walt
|
![]() |
![]() |
![]() |
#2 |
Senior Member
Join Date: Feb 2011
Location: Buchanan, MI
Posts: 677
|
![]()
Walt, it is so easy to solder the hole closed in a standard fitting and then drill it with a 1/16" (.062") drill. Use a little muratic(sp) acid to clean the fitting.
|
![]() |
![]() |
Sponsored Links (Register now to hide all advertisements) |
|
![]() |
#3 |
Senior Member
Join Date: May 2010
Location: on the Littlefield
Posts: 6,188
|
![]()
I once tapped a fitting and used a carb jet for the restriction ---don't remember what the jet was from, but it got the job done
|
![]() |
![]() |
![]() |
#4 |
Senior Member
Join Date: Jun 2012
Location: Gaylord, Michigan
Posts: 1,615
![]() |
![]()
Walt.....I think I saw these for sale in C & G catalog.
|
![]() |
![]() |
![]() |
#5 |
Senior Member
Join Date: Nov 2010
Location: NM
Posts: 2,438
|
![]()
__________________
'52 F-1, EAB flathead |
![]() |
![]() |
![]() |
#6 |
Senior Member
Join Date: May 2010
Location: NW Montana
Posts: 131
|
![]() Sponsored Links (Register now to hide all advertisements)
|
![]() |
![]() |
![]() |
#7 |
Senior Member
Join Date: Nov 2010
Location: NM
Posts: 2,438
|
![]()
__________________
'52 F-1, EAB flathead |
![]() |
![]() |
![]() |
#8 | |
Senior Member
Join Date: May 2010
Location: Canada Where it snows
Posts: 2,058
|
![]() Quote:
Walt it is a #1512 weather head fitting ![]() R |
|
![]() |
![]() |
![]() |
#9 |
Senior Member
Join Date: May 2010
Location: Gardiner Me.
Posts: 4,200
|
![]()
Thanks R for that weather head part no. Walt
|
![]() |
![]() |
![]() |
|
|
Sponsored Links (Register now to hide all advertisements) |
|