|
Sponsored Links (Register now to hide all advertisements) |
|
![]() |
![]() |
Thread Tools | Display Modes |
![]() |
#1 |
Senior Member
Join Date: Oct 2010
Posts: 101
|
![]()
Looking for a possible solution to a molded upper radiator hose for a '52 F1. Don't want the busy look of the hose / pipe setups or the flexible hose look. Went on the Gates and Dayco websites and there are a few possibilities by trimming existing molded hoses. Just wondering if there have been any previous known solutions?
|
![]() |
![]() |
![]() |
#2 |
Senior Member
Join Date: May 2010
Location: Newington, Connecticut
Posts: 1,374
|
![]()
There are molded hoses that replace the hose/ pipe/hose setup. I had some a few years ago but sold them. I believe they were an earlier car application. They were actually sold under the Mopar name originally.Watch Ebay as I've seen them there from time to time. I used them temporarily on my 50 F-1 V8.
__________________
Barry 50 F-1 |
![]() |
![]() |
Sponsored Links (Register now to hide all advertisements) |
|
![]() |
#3 |
Senior Member
Join Date: May 2010
Location: NW Montana
Posts: 131
|
![]()
I'd be interested as well. I have the ugly flexible ribbed ones now.
|
![]() |
![]() |
![]() |
#4 |
Senior Member
Join Date: May 2010
Location: Central New Jersey
Posts: 131
|
![]() Sponsored Links (Register now to hide all advertisements)
Don |
![]() |
![]() |
![]() |
|
|
Sponsored Links (Register now to hide all advertisements) |
|