Forum: Model T (1909-1927)
01-17-2017, 06:28 PM
|
|
Replies: 13
Views: 5,546
Re: Model T front axle
This is one of the parts that about any one with model T's have at least 3 or 4. If the axel is in perfect condition, with good threads and good spring perches with good threads and bushings, it...
|
|
Forum: Model T (1909-1927)
08-21-2016, 05:01 PM
|
|
Replies: 5
Views: 1,447
|
|
Forum: Model T (1909-1927)
08-12-2016, 03:02 PM
|
|
Replies: 3
Views: 1,255
Re: 1924 Tudor rear body bracket
If they are the same as my 25 tudor, they are just a flat steel strap about one quarter inch thick by two inch wide and about 8 inch long. These are fastened to the bottom of the wood sills and go at...
|
|
Forum: Model T (1909-1927)
05-01-2016, 10:13 AM
|
|
Replies: 6
Views: 1,669
Re: 26 Roadster on an earlier frame?
I think you will find it difficult. the 26 rear cross member is wider, the body mounts are located different. The frame for the 26 has special mounts for hood sills and the front cross member is...
|
|
Forum: Model T (1909-1927)
04-10-2016, 02:15 PM
|
|
Replies: 16
Views: 3,821
Re: replacing spokes
If you were closer to me, I have several good wheels. I live in Reed City, Mich.
|
|
Forum: Model T (1909-1927)
03-30-2016, 04:57 PM
|
|
Replies: 3
Views: 893
|
|
Forum: Model T (1909-1927)
03-25-2016, 02:22 PM
|
|
Replies: 2
Views: 1,229
|
|
Forum: Model T (1909-1927)
03-19-2016, 01:23 PM
|
|
Replies: 15
Views: 2,615
|
|
Forum: Model T (1909-1927)
03-18-2016, 01:43 PM
|
|
Replies: 3
Views: 1,380
|
|
Forum: Model T (1909-1927)
03-12-2016, 06:09 PM
|
|
Replies: 4
Views: 1,180
Re: Vehicle VIN question
Early 26 has the number on the drivers side. These have a different rear cross member without the flange. Later cars have the number on the passenger side
|
|
Forum: Model T (1909-1927)
02-28-2016, 06:51 PM
|
|
Replies: 12
Views: 2,109
|
|
Forum: Model T (1909-1927)
12-29-2015, 08:50 PM
|
|
Replies: 2
Views: 1,377
|
|
Forum: Model T (1909-1927)
12-08-2015, 06:44 PM
|
|
Replies: 9
Views: 1,715
Re: finding neutral in a different way
The clutch disk are not compressed or used when in low or reverse. When in high the disk are compressed and makes a solid connection from motor to driveshaft. in other words the disk are free to slip...
|
|
Forum: Model T (1909-1927)
10-20-2015, 08:09 AM
|
|
Replies: 8
Views: 1,753
Re: air fuel mix
No reason to unhook the forked rod. Adjust ccw for more fuel and cw for less. Usually turn open ccw some to start. Trial and error will show best amount to turn.
|
|
Forum: Model T (1909-1927)
07-13-2015, 12:23 PM
|
|
Replies: 3
Views: 1,401
Re: T time - 23 coupe
First I would recommend finding some one in your area that knows Model T's to guide you. Model T's do vibrate and rattle to some extent but you should have it checked. In hilly areas you must keep...
|
|
Forum: Model T (1909-1927)
06-06-2015, 02:39 PM
|
|
Replies: 9
Views: 2,191
Re: 26 Model T (High Gear/clutch forks)
Forget replacing clutch forks. In working on dozens of T engines I have never seen any wear. Possibly need adjusting. Is the engine running smooth? If the clutch was slipping , the engine would rev...
|
|
Forum: Model T (1909-1927)
05-31-2015, 06:12 AM
|
|
Replies: 2
Views: 1,758
Re: Oil leak
First check the bendix cover on the rear of the hogshead. then check the starter bolts. if they are ok it likely is the seal between the hogshead and the engine. Never try to remove starter without...
|
|
Forum: Model-T
01-27-2015, 02:04 PM
|
|
Replies: 0
Views: 1,422
|
|
Forum: Model-T
01-26-2015, 02:02 PM
|
|
Replies: 0
Views: 1,407
wire wheel hubs
Full set of wire wheel hubs, front hubs have bearings and dust caps.
|
|
Forum: Model T (1909-1927)
10-26-2014, 02:57 PM
|
|
Replies: 7
Views: 1,773
Re: Red Glass Lense
Is this the round style or square? It may say14 but that is just a patent date. It sounds like you may have a 15 cowl light. Easy to find and change the complete door but may not find one with the...
|
|
Forum: Model T (1909-1927)
10-20-2014, 04:40 PM
|
|
Replies: 7
Views: 2,267
Re: head gasket
You must install with the large water passages on the end,matching the holes in the block, One end is larger than the other.
|
|
Forum: Model T (1909-1927)
09-21-2014, 05:40 AM
|
|
Replies: 14
Views: 3,229
Re: How smooth should tranmission drums be?
OK you have me confused. You say new bands and then that you have no adjustment left. With new band linings you should have lots of adjustment. DO NOT scratch the drums!! they must be smooth. Please...
|
|
Forum: Model-T
08-15-2014, 11:59 AM
|
|
Replies: 0
Views: 1,345
to the guy looking for a rear spring leaf
I can not respond to mister Johnson's post but if you can not find the leaf you need.just cut the ends off a longer spring with a cut off wheel. I have done it many times.
|
|
Forum: Model-T
06-12-2014, 02:39 PM
|
|
Replies: 1
Views: 1,999
|
|
Forum: Model-T
06-05-2014, 06:58 PM
|
|
Replies: 1
Views: 1,999
|
