Forum: Model A (1928-31)
05-30-2024, 03:49 AM
|
Replies: 21
Views: 769
Re: help! clutch won‘t disengage…
well, i made it home but the car is in a garage in Leverkusen. I cannot do that repair in my little garage so i have to find a professional to do the job.
Do any of the german members here know...
|
Forum: Model A (1928-31)
05-29-2024, 12:35 PM
|
Replies: 21
Views: 769
|
Forum: Model A (1928-31)
05-29-2024, 11:59 AM
|
Replies: 21
Views: 769
|
Forum: Model A (1928-31)
05-29-2024, 11:53 AM
|
Replies: 21
Views: 769
|
Forum: Model A (1928-31)
05-29-2024, 11:43 AM
|
Replies: 21
Views: 769
|
Forum: Model A (1928-31)
05-29-2024, 11:28 AM
|
Replies: 21
Views: 769
|
Forum: Model A (1928-31)
05-29-2024, 11:23 AM
|
Replies: 21
Views: 769
help! clutch won‘t disengage…
okay, managed about 30mls before…
the clutch pedal fell to the floor, clutch won‘t disengage but i can see the ‚clutch bearing‘ move in and out when i move the pedal…
i noticed before that the...
|
Forum: Model A (1928-31)
05-29-2024, 06:11 AM
|
Replies: 18
Views: 679
Re: Leak on top of carb...
i have not had time yet to check the carb, but a thought crossed my mind...
My mixture screw is more or less closed, maybe the vacuum pulls in the fuel into the top of the carb and after the...
|
Forum: Model A (1928-31)
05-28-2024, 08:27 AM
|
Replies: 20
Views: 1,061
|
Forum: Model A (1928-31)
05-28-2024, 08:04 AM
|
Replies: 59
Views: 2,722
Re: Idle Mixture Screw
better to put a little pressue on it and use leak detection spray (used for checking gas (natural gas, propane) pipework for leaks. Should be readily available in any diy-store for a small amount of...
|
Forum: Model A (1928-31)
05-27-2024, 12:45 AM
|
Replies: 18
Views: 679
Re: Leak on top of carb...
guys,
thank you all, i will go through and check everything. I have been out over the weekend doing about 150 miles without any problems except i have to remember to shut the fuel off when...
|
Forum: Model A (1928-31)
05-26-2024, 12:05 PM
|
Replies: 18
Views: 679
|
Forum: Model A (1928-31)
05-26-2024, 10:57 AM
|
Replies: 18
Views: 679
|
Forum: Model A (1928-31)
05-26-2024, 10:38 AM
|
Replies: 18
Views: 679
|
Forum: Model A (1928-31)
05-26-2024, 10:14 AM
|
Replies: 18
Views: 679
Leak on top of carb...
Hi guys,
this is puzzling... at least to me...
I came to the car yesterday and found a puddle of fuel under it, about 1,5l. My carb has always been leaking but it was only dripping, not a lot....
|
Forum: Model A (1928-31)
05-14-2024, 06:39 AM
|
Replies: 10
Views: 548
Re: Blown exhaust gasket and rough idle?
my method of finding leaks in the inlet or exhaust train is to duct-tape the positive-pressure side of my vacuum cleaner (Hoover?) onto the carburettor or exhaust. then i use leak-detection spray and...
|
Forum: Model A (1928-31)
04-25-2024, 02:14 PM
|
Replies: 31
Views: 2,994
Re: Recommended Turning Signal Switch
Werner,
i am sorry you have had a bad experience with Berts. my experience is mixed, they do ship, but the communication is lacking. My favourite supplier is Snyders, but they do not sell this...
|
Forum: Model A (1928-31)
04-24-2024, 04:00 PM
|
Replies: 31
Views: 2,994
Re: Recommended Turning Signal Switch
Werner,
that's also been my experience with Bert's... But the parts arrived, so i assume that they are just not good at communicating. And, being sent by USPS, it may take three weeks for the...
|
Forum: Model A (1928-31)
04-17-2024, 03:10 AM
|
Replies: 13
Views: 2,602
|
Forum: Model A (1928-31)
04-09-2024, 11:36 AM
|
Replies: 14
Views: 970
Re: Condenser Capacity
'cause 1 F(arad) = 1 C(oulomb)/1V(olt), so this is the standard version in the S.I. system.
and 1Coulomb = 1Ampere * 1 second
|
Forum: Model A (1928-31)
04-03-2024, 02:18 AM
|
Replies: 23
Views: 1,646
Re: New Ahooga Horns from Suppliers
Don't forget that not all A owners are living in the US, i am not in the market for an Aoogah, but if i had to, i would go to my preferred seller. Getting a private seller to send a shipment to...
|
Forum: Model A (1928-31)
04-02-2024, 09:44 AM
|
Replies: 24
Views: 1,706
|
Forum: Model A (1928-31)
03-17-2024, 07:03 AM
|
Replies: 10
Views: 968
Re: Tires
coming back to this... i installed my european classics yesterday and did my first test drive at 37psi today: they seem better than the tires i had on before (which were really old) and i think i can...
|
Forum: Model A (1928-31)
03-15-2024, 02:14 AM
|
Replies: 19
Views: 1,283
|
Forum: Model A (1928-31)
03-14-2024, 01:40 AM
|
Replies: 24
Views: 1,342
Re: 1929 TwoLite headlamps w/ LED turn signals
a bit off topic,but nevertheless: i have the focused led headlights and am impressed with the brightness but don't like the cold-blue-white light. So i added incandescent lights in the 'parking...
|