The Ford Barn

marks1929tudor · 05-15-2013, 06:52 PM

From what I understand front door window replacement is pretty straight forward, but what about the rear side windows??? Heard they can be a pain ?? Any tips or tricks to make this easy????

marks1929tudor · 05-15-2013, 11:14 PM

Since I have not seen what mine looks like inside , could someone explain this a little better??

700rpm · 05-15-2013, 11:20 PM

Sponsored Links (Register now to hide all advertisements)

It is a pain. You have to unscrew the inside metal support panel and pull it away from the body. Install your weatherstripping and slide the glass in from the bottom. It's a struggle, and you'll learn a lot about it when you remove the old glass.

The doors are pretty direct and easy.

Also, if you do an advanced search here, there are some earlier (and probably better) descriptions on this topic.

05-15-2013, 06:52 PM	#1
marks1929tudor Junior Member Join Date: May 2012 Posts: 10	Replacing windows 29 Tudor From what I understand front door window replacement is pretty straight forward, but what about the rear side windows??? Heard they can be a pain ?? Any tips or tricks to make this easy????

05-15-2013, 11:14 PM	#2
marks1929tudor Junior Member Join Date: May 2012 Posts: 10	Re: Replacing windows 29 Tudor Since I have not seen what mine looks like inside , could someone explain this a little better??

05-15-2013, 11:20 PM	#3
700rpm Senior Member Join Date: May 2010 Location: Portland, Oregon Posts: 5,902	Re: Replacing windows 29 Tudor Sponsored Links (Register now to hide all advertisements) It is a pain. You have to unscrew the inside metal support panel and pull it away from the body. Install your weatherstripping and slide the glass in from the bottom. It's a struggle, and you'll learn a lot about it when you remove the old glass. The doors are pretty direct and easy. Also, if you do an advanced search here, there are some earlier (and probably better) descriptions on this topic. __________________ Ray Horton, Portland, OR As you go through life, keep your eye on the donut, not the hole.

Thread Tools
Show Printable Version Email this Page
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode