|
Sponsored Links (Register now to hide all advertisements) |
|
|
Thread Tools | Display Modes |
09-06-2018, 11:25 PM | #1 |
Senior Member
Join Date: Aug 2017
Location: St. Maries, Idaho
Posts: 162
|
Might have screwed up
Not sure but I may have screwed up . I removed my crankshaft pulley nut with my air impact gun. After I did, I got to wondering if I may have damaged the rod bearings. I did not rattle on it very long before it came out but now I am concerned. Should I be?
|
09-06-2018, 11:32 PM | #2 |
Senior Member
Join Date: Dec 2011
Location: New hope Minnesota
Posts: 742
|
Re: Might have screwed up
I doubt that you hurt anything.
|
Sponsored Links (Register now to hide all advertisements) |
|
09-06-2018, 11:35 PM | #3 |
Senior Member
Join Date: May 2010
Location: PASADENA, CA
Posts: 1,884
|
Re: Might have screwed up
I doubt that you hurt anything.
The crank has a lot of mass to it and the rod bearings will be fine. If the flywheel was still attached to the crank, the rod bearings would not even know something was going on. My opinion, Chris W. |
09-07-2018, 08:08 AM | #4 |
Senior Member
Join Date: Aug 2017
Location: St. Maries, Idaho
Posts: 162
|
Re: Might have screwed up
Sponsored Links (Register now to hide all advertisements)
|
|
|
Sponsored Links (Register now to hide all advertisements) |
|