|
Sponsored Links (Register now to hide all advertisements) |
|
|
Thread Tools | Display Modes |
02-07-2015, 09:30 AM | #1 |
Senior Member
Join Date: May 2010
Location: NW Arkansas
Posts: 361
|
30 vs 31 front fenders
Is it possible to remove the apron extension on a 30 fender and use it on a 31?
|
02-07-2015, 09:45 AM | #2 |
Senior Member
Join Date: May 2010
Location: South East NJ
Posts: 3,398
|
Re: 30 vs 31 front fenders
The flange may need to be extended to have enough room to make room for the bolt holes. The flange on some of the 30 fenders I have seen were not long enough to allow for the elongated bolt holes used on the 31. Yes, Ford had oval holes to allow for room with fitting.
|
Sponsored Links (Register now to hide all advertisements) |
|
02-07-2015, 09:46 AM | #3 |
Senior Member
Join Date: May 2010
Location: Eastern Tennessee
Posts: 11,509
|
Re: 30 vs 31 front fenders
Yes but you will need to extend that flange by about .250-.350 where you can drill the holes to bolt the one-piece aprons to.
|
02-07-2015, 09:47 AM | #4 |
Senior Member
Join Date: May 2010
Location: Eastern Tennessee
Posts: 11,509
|
Re: 30 vs 31 front fenders
Sponsored Links (Register now to hide all advertisements)
|
|
|
Sponsored Links (Register now to hide all advertisements) |
|