08-17-2019, 04:12 PM | #1 |
Senior Member
Join Date: Dec 2015
Posts: 547
|
F1 axle shafts
I am restoring a set of axle shafts to slide into a Dana 44, new bearings/derusting/speedi sleeves to repair a slight groove. While I have them clean and easy to get to, should I paint the unmachined section of the shaft. I was thinking a light coat of glyptal but wanted to get the expert opinions.
JB |
08-17-2019, 06:10 PM | #2 |
Senior Member
Join Date: May 2010
Location: Masterton, New Zealand
Posts: 3,834
|
Re: F1 axle shafts
Sponsored Links (Register now to hide all advertisements)
__________________
Unfortunately, two half wits don't make a whole wit! |
Sponsored Links (Register now to hide all advertisements) |
|
|
|
Sponsored Links (Register now to hide all advertisements) |
|