The Ford Barn

miken7132 · 05-13-2010, 08:32 AM

I rebuilt a universal joint that I purchased through ebay using a kit from Brattons (cross, bushings, and clips). The rebuilt joint has about 1/8 to 1/4 inch of play across each yoke. Is this normal? When I bolted it to the transmission drive, put on the rear cap, and rotated the joint, I noticed a sound like metal rubbing on metal. I assume its the joint rubbing against the inside of the cap. Will this go away once the engine/transmission is hooked up to the drive shaft/torque tube putting the drive train in alignment?

05-13-2010, 08:32 AM	#1
miken7132 Junior Member Join Date: May 2010 Posts: 15	Universal joint I rebuilt a universal joint that I purchased through ebay using a kit from Brattons (cross, bushings, and clips). The rebuilt joint has about 1/8 to 1/4 inch of play across each yoke. Is this normal? When I bolted it to the transmission drive, put on the rear cap, and rotated the joint, I noticed a sound like metal rubbing on metal. I assume its the joint rubbing against the inside of the cap. Will this go away once the engine/transmission is hooked up to the drive shaft/torque tube putting the drive train in alignment?

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode