|
Sponsored Links (Register now to hide all advertisements) |
|
|
Thread Tools | Display Modes |
05-19-2020, 09:24 AM | #1 |
Senior Member
Join Date: Jan 2012
Location: New Jersey
Posts: 356
|
What do we think of this
Hi once again, So i'm gonna set my water pump clearance to between .006 and .010 in. don't know how to do it? So what I did was measured my new pump gasket at .033 in. , I fabricated another gasket at .025in and will now put it together with that gasket , push the shaft in tight , set the locking ring in this position then remove the pump and gasket and install the new gasket [ .033] and I will have obtained the correct spacing. WHAT DO WE THINK?? thanks THE HOOCH
|
05-19-2020, 10:32 AM | #2 |
Senior Member
Join Date: May 2010
Location: Alabama
Posts: 8,099
|
Re: What do we think of this
Sponsored Links (Register now to hide all advertisements)
|
Sponsored Links (Register now to hide all advertisements) |
|
|
|
Sponsored Links (Register now to hide all advertisements) |
|