Help I’m Lost

[tubman]

Originally Posted by Lanny

===============================================

Hey Denny, do have a condenser that fits this young guys '34 ?

.

Although I have sold a bunch to guys who have used them on "Helmets", "Crabs", and "Rabbit-ears" with consistent success, most folks consider them too costly for general use (and they are right).

However, if he continues to have trouble, I would consider sending him one "on approval" to see if it helps. The postage would be the limiting factor here.

As a matter of fact, I am going to discontinue making them when my current stock of components runs out. The price of brass and electronic components has gone through the roof lately.

[34 fordor owner]

I plan on contacting skip and sending him my coil and asking him about the condenser and ballast resistor like you said Lanny. Tinker, I have checked the connections on my battery they are good but I have replaced the positive ground cable because of the wire heating up, after the new cable was put on it no longer got hot. Again thank y’all for the help!

[34 fordor owner]

Originally Posted by Lanny

===============================================

Here is some Skip Haney info for you...

Click on picture to Enlarge.

Does anyone know if this is still the correct information? I tried to call the “day” number it did not ring.

[Lanny]

Call the night number 941-505-9085




.

[34 fordor owner]

Originally Posted by Lanny

Call the night number 941-505-9085




.

I got in contact with him and the coil is being sent out tomorrow and he is going to be testing the condenser for me as well. Thank y’all!

[Lanny]

Sponsored Links (Register now to hide all advertisements)

In your 1st post here, you say that you installed a rebuilt dist.
Was it rebuilt by a competent rebuilder, or picked up at a swap
meet, OR ???
The points in the dist must be set exactly, for it to work right.





.

[34 fordor owner]

Originally Posted by Lanny

In your 1st post here, you say that you installed a rebuilt dist.
Was it rebuilt by a competent rebuilder, or picked up at a swap
meet, OR ???
The points in the dist must be set exactly, for it to work right.





.

It was sent of to a builder and was rebuilt and as far as I know set up correctly.

[Lawson Cox]

Originally Posted by 34 fordor owner

Does anyone have a good recommendation of where to get a good coil for a dome distributor?

Send your coil to Skip Haney in Florida to get it rebuilt better than new. He can furnish a proper condenser at the same time. About $80.00 plus the ride, but I'm not pricing his service by any means.

[34 fordor owner]

Alright guys, got my coil back from skip today and it looks great! I do need a new condenser though. Does anyone have good suggestions for condensers for the “dome” style distributor?

[Lanny]

Originally Posted by 34 fordor owner

Alright guys, got my coil back from skip today and it looks great! I do need a new condenser though. Does anyone have good suggestions for condensers for the “dome” style distributor?

On post # 61, tubman (Denny) may have one. PM him, he's a good guy.


Or you could try: Third Generation Automotive, Michael Driskel
at 844-327-5988 tomorrow.





.

[junglejim]

Any updates on this?
Jim

[Lanny]

34 fordor owner started a new thread when he got the condenser,
and he is looking for info on hooking the condenser up to his coil.

Below is a link to his New thread...

https://www.fordbarn.com/forum/showthread.php?t=306349




.