|
Sponsored Links (Register now to hide all advertisements) |
|
|
Thread Tools | Display Modes |
01-05-2020, 06:59 PM | #1 |
Member
Join Date: Aug 2011
Location: Chico,Ca
Posts: 72
|
charge battery via alternator lug
This is a 31 ford stock except for a 12V system with a single wire output Alternator. Can I charge the battery (witch is hard to access) with out harming the diodes by connecting one lead of the charger to the alternator lug and the other to ground? See any problems with that? Negative ground. Thanks
|
01-05-2020, 07:11 PM | #2 |
Senior Member
Join Date: May 2010
Location: Young Harris, GA
Posts: 1,815
|
Re: charge battery via alternator lug
Yes, you can do that, if it is a low amp charger (up to 10 amps). You are correct, it is a very easy place to connect to. You can also connect to either of the little wing nuts on the front of the terminal box (on the firewall).
You can also connect the charger clip to the big post on the starter switch where the battery cable connects to the switch. That cable can take all the amps you want to throw at it. But be careful with the clip around the starter switch or it will short out as you connect to the post. Double check the polarity of the charger alligator clips, compared to the battery install. Don't get it backwards. Stock wiring was positive ground, but your 12 volt car may now be negative ground.
__________________
Jim Cannon Former MAFCA Technical Director "Have a Model A day!" Last edited by Jim/GA; 01-06-2020 at 06:48 PM. |
Sponsored Links (Register now to hide all advertisements) |
|
01-06-2020, 02:31 PM | #3 |
Senior Member
Join Date: Jun 2010
Location: Temecula, CA
Posts: 4,085
|
Re: charge battery via alternator lug
Amen!
|
01-06-2020, 05:27 PM | #4 |
Senior Member
Join Date: May 2010
Location: Durango CO
Posts: 1,309
|
Re: charge battery via alternator lug
You can see the positive post on my remote battery terminals. About $20 a pair at Speedway plus cables. Easy to use jumper cables and trickle chargers
__________________
No restorable Model A's were harmed in the building of this truck! |
01-10-2020, 11:47 AM | #5 |
Member
Join Date: Aug 2011
Location: Chico,Ca
Posts: 72
|
Re: charge battery via alternator lug
A little delayed, but thanks all for the reassurance and suggestions. Bruce
|
01-10-2020, 12:09 PM | #6 |
Senior Member
Join Date: Dec 2014
Location: Santa Maria, CA
Posts: 985
|
Re: charge battery via alternator lug
Sponsored Links (Register now to hide all advertisements)
__________________
Alan 1929 Special Coupe 1941 Pick-Up 1955 Victoria |
01-10-2020, 01:24 PM | #7 |
Senior Member
Join Date: Apr 2018
Location: Mebane NC
Posts: 2,350
|
Re: charge battery via alternator lug
This is awesome, I did not know this was a thing. So I can charge my 6V-pos. ground battery (3A charger) by connecting the red lead to ground and the black lead to that nut on the starter switch? No manual disconnecting of anything required?
|
01-10-2020, 01:35 PM | #8 |
Senior Member
Join Date: Jun 2015
Location: Red Deer, Alberta
Posts: 5,042
|
Re: charge battery via alternator lug
"that nut on the starter switch" is a direct connection to the battery negative terminal unless there's a disconnect switch in between.
__________________
If you don't hear a rumor by 10 AM, start one!. Got my education out behind the barn! Last edited by katy; 01-10-2020 at 01:35 PM. Reason: Addition |
01-10-2020, 02:06 PM | #9 |
Senior Member
Join Date: Apr 2018
Location: Mebane NC
Posts: 2,350
|
Re: charge battery via alternator lug
I realize that, I mainly wanted to confirm that there's no risk of damage to the electrical components by leaving the normal circuit in place. Previously, if I wanted to charge the battery, I would open the access port in the floorboard, disconnect the ground cable, and connect my charging leads. It would be nice not to have to do that.
|
01-11-2020, 09:37 AM | #10 | |
Senior Member
Join Date: Aug 2011
Location: Eagle Bend, MN
Posts: 2,025
|
Re: charge battery via alternator lug
Quote:
__________________
"There are some that can destroy an anvil with a teaspoon and shouldn't be allowed to touch anything resembling a tool." |
|
01-11-2020, 10:15 AM | #11 |
Senior Member
Join Date: Jun 2010
Location: San Antonio, Texas
Posts: 16,425
|
Re: charge battery via alternator lug
That post on the alternator is where the output comes through after it passes through the diode bridge in the alternator. The diodes are generally pretty tough and can hold fast against a back current flow. The bridge is what rectifies the AC current to DC for charging plus it acts like a cut out for back voltage or current. If you connect anywhere on the bus then you are also connecting to all points previously mentioned since they all share the bus circuit. Ground is ground and can be connected to anywhere on the vehicle that is bonded with the frame. A dedicated ground location should be bare metal and be protected with something like silicon grease to keep it from corrosive effects. The starter switch is likely the best place to access the bus circuit and it should be protected against corrosion as well.
If folks have a regular lead acid battery, it should be checked on a regular schedule for electrolyte levels up to par. Take good care of the battery and it will take good care of you. |
|
|
Sponsored Links (Register now to hide all advertisements) |
|