Go Back   The Ford Barn > General Discussion > Model A (1928-31)

Sponsored Links (Register now to hide all advertisements)

Reply
 
Thread Tools Display Modes
Old 02-15-2014, 10:57 AM   #1
grantsauder
Member
 
grantsauder's Avatar
 
Join Date: Nov 2012
Location: St. Davids, Ontario, Canada
Posts: 84
Default 1930 Rebuild Splash shield Bolts to Frame

I am restoring a 1930 Tudor which was never together in my time. Bratton's #22160 shows 4- 1/4-20 x3/4" step bolts to body running board splash shield to frame. Where are these bolts located ? I found two located at the rearmost holes in the shield. Where are the other two located? Hopefully the body will be installed on Tues.
Thank for your help.
Grant
grantsauder is offline   Reply With Quote
Old 02-15-2014, 03:31 PM   #2
Ken Ehrenhofer
Senior Member
 
Join Date: May 2010
Location: Woodstock, Illinois
Posts: 597
Default Re: 1930 Rebuild Splash shield Bolts to Frame

Sponsored Links (Register now to hide all advertisements)
Hi Grant
I believe you are referring to the two bolts that go thru the splash apron and thru the frame with frame welting between them. There is one bolt in each top corner of each apron. That will make for a total of 4 with both aprons,
The two holes in the rear are for attaching the rear fender,
Good Luck,
Ken
Ken Ehrenhofer is offline   Reply With Quote
Sponsored Links (Register now to hide all advertisements)
Reply

Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump

Sponsored Links (Register now to hide all advertisements)


All times are GMT -5. The time now is 06:12 PM.