|
Sponsored Links (Register now to hide all advertisements) |
|
|
Thread Tools | Display Modes |
08-11-2019, 05:18 PM | #1 |
Junior Member
Join Date: Apr 2014
Posts: 5
|
Rotor discrepancy on 8ba flathead V8
I have a 239 ci 8ba v8 flathead I went to change the rotor on a tuneup and discovered that the rotor was larger than the distributor shaft! Someone took a beer can and cut a small piece of it to take up the slack ! Of course this meant it would run for a while and then just quit! After a few minutes it would start again! Has anyone else run into this problem? I am at the point that I will buy an Electronic ignition distributor to fix this . What is the best distributor to buy for a 1949 to 1953 Ford 8ba flathead v8? Or can I buy the right rotor?
|
08-11-2019, 06:56 PM | #2 |
Senior Member
Join Date: May 2010
Location: Southern California
Posts: 7,017
|
Re: Rotor discrepancy on 8ba flathead V8
Sponsored Links (Register now to hide all advertisements)
Sorry I don't know the answer to your question, if I did I would post it. Charlie Stephens |
Sponsored Links (Register now to hide all advertisements) |
|
Thread Tools | |
Display Modes | |
|
|
Sponsored Links (Register now to hide all advertisements) |
|