|
Sponsored Links (Register now to hide all advertisements) |
|
|
Thread Tools | Display Modes |
11-17-2019, 02:31 PM | #21 |
Senior Member
Join Date: Feb 2011
Posts: 2,109
|
Re: Snyder’s Inserted Rod Size?
Not to stifle creative thinking but i am past past that point.
Back to my original post, If i cannot find someone with a rod ill break down and order a set of bearings soon. Thanks yall’
__________________
Tim Downtown, Ca |
11-17-2019, 03:22 PM | #22 |
Senior Member
Join Date: May 2010
Location: Portland OR
Posts: 6,339
|
Re: Snyder’s Inserted Rod Size?
How about this; My op is no two of us measure exactly the same. I could for example measure the ones we have in the shop, do I want to be responsible if not 100% correct, no I do not. Just ordering bearings is not going to give you the crush needed to install them unless you are going to take that in to account. If no one is forthcoming with the needed info, maybe order one rod to take your own and use as a master. Have you posted this question over on HAMB? Maybe someone there has the information.
__________________
I know the voices aren't real but damn they have some good ideas! |
Sponsored Links (Register now to hide all advertisements) |
|
Thread Tools | |
Display Modes | |
|
|
Sponsored Links (Register now to hide all advertisements) |
|