'31 welting.

[Licensed to kill]

Should there be a beaded welt between the fuel tank and the cowl on the '31's?.

[Pmsqrd]

Yes. The bead is smaller in diameter than the bead on the fender welt. It was originally installed prior to painting and ended up being lower body color.

[Bob C]

Here's a couple of pictures Marco posted.


Bob

[nick c]

I just did my 29 cc last night, its called cowl welt, 10', part # a3405cw, theres enough to start at the bottom of a door pillar then up and over the top of tank and down the other side, this one piece, the left over is for the 2 sides. I used a paper hole punch 1/4". I used gas tank anti squeak a9006 only on the front edge where the tank and cowl bolt up.
carry on

[Licensed to kill]

Thanks. That is what i thought but wanted to be sure.

[Steve Plucker]

Sponsored Links (Register now to hide all advertisements)

Originally Posted by nick c

I just did my 29 cc last night, its called cowl welt, 10', part # a3405cw, theres enough to start at the bottom of a door pillar then up and over the top of tank and down the other side, this one piece, the left over is for the 2 sides. I used a paper hole punch 1/4". I used gas tank anti squeak a9006 only on the front edge where the tank and cowl bolt up.
carry on

Originally, there was no welt on the sides of a 28-29 gastank.

Pluck