|
Sponsored Links (Register now to hide all advertisements) |
|
|
Thread Tools | Display Modes |
10-13-2013, 07:01 PM | #1 |
Senior Member
Join Date: Jun 2011
Location: West Point, VA 23181
Posts: 373
|
Anti-Rattle Campain
All,
I purchased a new door bumper set and a new hood bumper set: 1.) What do I use to set the hollow rivets that hold the 6 rubber 'snubbers' onto the hood at the latches and center support? 2.) How do I remove and replace the brass & rubber pieces in the door (closing) edge that mate with the dove tail on the post? BTW: I already lapped the valves, installed an original dash light and rebuilt the gas gage this weekend. If it stops raining, I hope to drop and clean the oil pan tomorrow. Thanks in advance; pictures would be great! R/Roger. |
10-13-2013, 09:00 PM | #2 |
Senior Member
Join Date: May 2010
Location: Mpls, MN
Posts: 27,582
|
Re: Anti-Rattle Campain
Sponsored Links (Register now to hide all advertisements)
|
Sponsored Links (Register now to hide all advertisements) |
|
Thread Tools | |
Display Modes | |
|
|
Sponsored Links (Register now to hide all advertisements) |
|