Wiring harness clip location

[dlevy]

Hi
Snyder’s sells a clip that bolts to the frame called the, “Light Wire Clip A-14589”.
There is a picture of it in one of their older catalogs up near one of the hood hold-downs on the left frame, but I cannot make out where it goes exactly.
Can someone please provide a better picture?
Thanks
Dave

[1930artdeco]

As far as I know they can go wherever you want them to go. There is no set place as it just keeps the wiring loom in the frame rail. This way it doesn't flop down and get damaged by anything.


Mike

[Curtis in MA]

That is a bolt on one that they use the same bolt as the latch.

[dlevy]

Thank you.
I know this is a detail question, but do you know if it was factory on front or rear hood latch bolt?
Dave

[Bob C]

The Standards say it was held by the rear screw of the front hood fastener.

[Jim Mason]

Sponsored Links (Register now to hide all advertisements)

Ford used it after April 1929

[dlevy]

That's great! Exactly what I needed to know.

Thank you very much!

Dave