|
Sponsored Links (Register now to hide all advertisements) |
|
|
Thread Tools | Display Modes |
08-11-2021, 03:57 PM | #1 |
Member
Join Date: Jul 2021
Posts: 76
|
Stop Light Switch routing
The wiring loom branch for my stop light goes through the battery holder for my 28 Roadster pick-up. This doesn't seem right. Also the wire loom comes up short on the stop lamp in the rear. Should the wire run from the switch through the cross member and then along the frame?
Also, some wire clips surround the wire loom and others pinch the loom in the middle. Which is correct or should they alternate? Thanks Bob |
08-11-2021, 05:23 PM | #2 |
Senior Member
Join Date: Dec 2017
Location: Guthrie, OK
Posts: 1,145
|
Re: Stop Light Switch routing
Clips should not pinch the loom. There is an extension between the end of the loom and stop/tail lamps which I believe length varies with model, has a special clip to attach to fender bracket. There is also an add-on loom to connect to the right side, if added. Not sure about 28 - on my 30 coupe the brake wires just hang between the switch and the loom along the rail. Loom runs between battery holder and frame rail, a bad place for battery spillage. Cloth loom can be protected with a length of plastic loom.
|
Sponsored Links (Register now to hide all advertisements) |
|
08-12-2021, 11:37 AM | #3 |
Senior Member
Join Date: May 2010
Location: Mpls, MN
Posts: 27,582
|
Re: Stop Light Switch routing
Sponsored Links (Register now to hide all advertisements)
|
|
|
Sponsored Links (Register now to hide all advertisements) |
|