|
Sponsored Links (Register now to hide all advertisements) |
|
|
Thread Tools | Display Modes |
12-19-2017, 05:23 PM | #1 |
Senior Member
Join Date: Aug 2017
Location: St. Maries, Idaho
Posts: 162
|
A couple break questions
1. What is the max allowable inside diameter of the break drums? 31 coupe
2. what is the thickness of "new" break shoes including both the fiber material and the steel shoe itself. Just trying to determine what I have in the way of wear. thanks Steve |
12-20-2017, 12:14 AM | #2 |
Senior Member
Join Date: May 2010
Location: PASADENA, CA
Posts: 1,884
|
Re: A couple break questions
The original brake drums were 11.000 in. If they are stamped steel, they can only be turned out to 11.030 in. Late 31 cast iron drums could probably go out to 11.060.
I believe the original lining itself was only about 3/16 in thick. I would have to measure a shoe to get the original thickness of the shoe itself but I suspect the shoe is something around .060-.080 inches but this is just a guess Your linings should not be worn down to where the rivets will be touching the drums. Chris W. |
Sponsored Links (Register now to hide all advertisements) |
|
12-20-2017, 09:04 AM | #3 |
Senior Member
Join Date: Oct 2017
Location: NC Mountains
Posts: 689
|
Re: A couple break questions
Sponsored Links (Register now to hide all advertisements)
|
|
|
Sponsored Links (Register now to hide all advertisements) |
|