Go Back   The Ford Barn > General Discussion > Early V8 (1932-53)

Sponsored Links (Register now to hide all advertisements)

Reply
 
Thread Tools Display Modes
Old 04-09-2019, 08:56 PM   #1
Lawson Cox
Senior Member
 
Lawson Cox's Avatar
 
Join Date: May 2010
Location: Above the gnat line in Georgia
Posts: 7,009
Default White vinegar as radiator flush

What are the do's and don'ts of flushing radiator with white vinegar. Also, what's the best rust preventer after flush. Thanks guys.
__________________
Life is like a roll of toilet paper. The closer to the end, the faster it goes.

It is better to be seen, than viewed.

"We sleep safe in our beds because rough men stand ready in the night to visit violence on those who would do us harm".
Lawson Cox is offline   Reply With Quote
Old 04-09-2019, 09:58 PM   #2
M2M
Senior Member
 
M2M's Avatar
 
Join Date: Jul 2012
Location: Australia/USA/EU/Soviet Russia
Posts: 1,105
Default Re: White vinegar as radiator flush

I've just done this with my model A. Vinegar sold in the USA is weak at only 5 or 6 % strength. I poured it into a non-running car and left it in there for almost three days. Then flushed the system with baking soda mixed with water to neutralize any acidity. Then flushed a few more times with simple green.
__________________

M2M is offline   Reply With Quote
Sponsored Links (Register now to hide all advertisements)
Old 04-10-2019, 07:32 AM   #3
alanwoodieman
Senior Member
 
Join Date: May 2010
Location: upstate SC
Posts: 2,962
Default Re: White vinegar as radiator flush

put in vinegar, run thru a least three cold hot cycles and then flush out with water and then add baking soda water mixture and run to temp and flush while it is running, you will not believe how much crud comes out
alanwoodieman is offline   Reply With Quote
Old 04-10-2019, 08:46 AM   #4
32phil
Senior Member
 
Join Date: May 2010
Location: Montgomery, NY & Port St. Lucie Florida
Posts: 934
Default Re: White vinegar as radiator flush

Just curious.....has anyone tried Evaporust as a radiator flush ?
It does a great job cold but it really works well/quickly hot.
__________________
Early Ford Lock & Key Service
https://www.fordbarn.com/forum/showthread.php?t=46583
32phil is offline   Reply With Quote
Old 04-10-2019, 09:17 AM   #5
tubman
Senior Member
 
tubman's Avatar
 
Join Date: Dec 2013
Location: Minnesota, Florida Keys
Posts: 10,260
Default Re: White vinegar as radiator flush

Quote:
Originally Posted by 32phil View Post
Just curious.....has anyone tried Evaporust as a radiator flush ?
It does a great job cold but it really works well/quickly hot.
I have used "Rust 911", which which works like Evaporust, but is a little cheaper. I thought the results were very good. I filled the system with it, ran three heat and cool cycles, and then drained and flushed it. I did this twice. Check out post #8 in this thread for pictures : https://www.fordbarn.com/forum/showt...light=rust+911

A poster named "Old Henry" (or maybe that was what he called his car) did a pretty detailed thread in which he did a cleanup on his water pumps. The results were pretty impressive. Look at post #30 on this thread : https://www.fordbarn.com/forum/showt...aporust&page=2

Last edited by tubman; 04-10-2019 at 09:27 AM.
tubman is offline   Reply With Quote
Old 04-10-2019, 09:31 AM   #6
texas webb
Senior Member
 
Join Date: Dec 2010
Location: San Antonio Texas
Posts: 636
Default Re: White vinegar as radiator flush

Sponsored Links (Register now to hide all advertisements)
Pickling vinegar is 9 percent and works well.The flush is important.
texas webb is offline   Reply With Quote
Old 04-10-2019, 10:25 AM   #7
JM 35 Sedan
Senior Member
 
JM 35 Sedan's Avatar
 
Join Date: May 2010
Location: Near Rising Sun, Maryland
Posts: 10,856
Default Re: White vinegar as radiator flush

Quote:
Originally Posted by M2M View Post
I've just done this with my model A. Vinegar sold in the USA is weak at only 5 or 6 % strength. I poured it into a non-running car and left it in there for almost three days. Then flushed the system with baking soda mixed with water to neutralize any acidity. Then flushed a few more times with simple green.
Exactly what I did on my 35 Fordor (avatar) several years ago. I could not believe what came out. Neutralizing acidic mix with baking soda is an important step after flush.
__________________
John

"Never give up on what you really want to do. The person with big dreams is more powerful than one with all the facts". Albert Einstein
JM 35 Sedan is offline   Reply With Quote
Old 04-10-2019, 10:56 AM   #8
philipswanson
Senior Member
 
Join Date: Oct 2015
Location: Bonita, CA
Posts: 1,374
Default Re: White vinegar as radiator flush

Put two cups of straight phosphoric acid in it, then flush with backing soda after a couple of hundred miles. Repeat as necessary. You might have to do this several times in a really bad system. If you have a clogged radiator, reverse flush or rod out.
philipswanson is offline   Reply With Quote
Old 04-10-2019, 12:55 PM   #9
jrhaelig
Senior Member
 
jrhaelig's Avatar
 
Join Date: Mar 2011
Location: Bridgewater, New Jersey
Posts: 264
Default Re: White vinegar as radiator flush

Just be mindful of the other crud that may come loose.

I flushed the radiator on my '39 Buick with vinegar, then the soap from a dishwasher gel pack (they are all super-low sudsing).

Anyway - busted loose all kinds of crud in the block - that subsequently clogged my radiator!

The old stocking filter on the inlet pipe might have prevented the removal and professional cleaning that followed.

Good luck!
__________________
John Haelig
Bridgewater, NJ
1939 Ford Pickup
1963 Lincoln Continental
1939 Buick
jrhaelig is offline   Reply With Quote
Old 04-10-2019, 01:02 PM   #10
1931 flamingo
Senior Member
 
1931 flamingo's Avatar
 
Join Date: May 2010
Location: new britain,ct 06052
Posts: 9,389
Default Re: White vinegar as radiator flush

After doing the vinegar trick do NOT drain and flush on a concrete drive way...FWIW.
Paul in CT
1931 flamingo is offline   Reply With Quote
Old 04-10-2019, 03:33 PM   #11
Drbrown
Senior Member
 
Drbrown's Avatar
 
Join Date: Oct 2013
Location: Glens Falls NY
Posts: 1,267
Default Re: White vinegar as radiator flush

Just a point of reference, couple years back Old Henry posted a thread here about his testing of cooling system flushing components, including vinegar. I believe he found vinegar (don't know what strength) to have a short-active-life, at least effect compared to Evaporust and/or others.

Might be worthwhile to find what he had to say.
Drbrown is offline   Reply With Quote
Old 04-10-2019, 05:08 PM   #12
v8nut
Senior Member
 
v8nut's Avatar
 
Join Date: Dec 2010
Location: San Jose, CA
Posts: 202
Default Re: White vinegar as radiator flush

I would recommend using a product available from Harbor Freight called Rust 911. It is a colorless odorless concentrate that you dilute with water for use. It may be similar to Evaporust . Use as directed. I think you will find it more effective than vinegar. I used it to lean up a radiator that was completely blocked with rust and scale. Jim in San Jose.
v8nut is offline   Reply With Quote
Old 04-10-2019, 06:48 PM   #13
tubman
Senior Member
 
tubman's Avatar
 
Join Date: Dec 2013
Location: Minnesota, Florida Keys
Posts: 10,260
Default Re: White vinegar as radiator flush

I use "Rust-911" when I have large pieces. It works the same as "Evaporust", but from my experience, not quite as well. I think it is because it is a concentrate.

I would recommend those of you that are recommending vinegar review the "Old Henry" Thread mentioned in my earlier post (and one other). It is an acid and can damage cast iron and steel if used too long. Be very careful with it.
tubman is offline   Reply With Quote
Old 04-10-2019, 07:59 PM   #14
adileo
Senior Member
 
adileo's Avatar
 
Join Date: Jun 2014
Location: New Jersey
Posts: 1,772
Default Re: White vinegar as radiator flush

My 39 always had an issue running hot at at (on most summer days) 210. This is with 170 stats. Didn’t matter whether I was doing city driving or highway.

I pulled it over the winter and brought it to a radiator shop. He cleaned it chemically and then pressure tested it. Cost was best $80 bucks I spent in a long time. Car runs at a constant 170.

I should also mention, I think this is original radiator with the split down middle.
__________________
Thanks

Andy
1952 F1
adileo is offline   Reply With Quote
Old 04-10-2019, 08:08 PM   #15
woofa.express
Senior Member
 
woofa.express's Avatar
 
Join Date: Jan 2018
Location: Tocumwal, NSW, Australia
Posts: 1,744
Default Re: White vinegar as radiator flush

I used strait vinegar into a new radiator to clean out the block in my Model A. The new radiator had a flaw and leaked where the upper neck is soldered to the top tank. What a mess in the engine compartment and onto my slick paint job.
I also found vinegar must be followed by baking soda to get a clean radiator and block.
__________________
I know many things,
But I don't know everything,
Sometimes I forget things.

And there are times when I have a long memory.
woofa.express is offline   Reply With Quote
Old 04-10-2019, 09:13 PM   #16
VeryTangled
Senior Member
 
VeryTangled's Avatar
 
Join Date: May 2010
Location: (Not far enough...) Outside of DC
Posts: 3,386
Default Re: White vinegar as radiator flush

Quote:
Originally Posted by 32phil View Post
Just curious.....has anyone tried Evaporust as a radiator flush ?
It does a great job cold but it really works well/quickly hot.
Yes I personally have, sorta. Using the similar product Rust-911, I was satisfied. Except for the volume of waste fluids it did what I wanted. 5 Gal of de-rust mix, and twice 5 gal of flush, so a lot of liquids to recycle.

My eventual solution was a recored radiator, but that was not the reason Rust-911 didn't solve the issue. I did an engine swap and lucked into a super fresh rad to exchange in at the same time as the powerplant.

And if any of you readers somehow have not had it register yet. Check out what Craig/Old Henry documented. He laid out a very good case! His deal is doing that against the Gummint' for us wronged citizens. So realize he's arguing a viewpoint. You can/should judge if it's the correct argument for your situation. A good guy and I miss his contributions. Hope he hasn't trashed too many aero-vehicles. Lord knows I've broken a few in my younger days.
__________________
-Jeff H

Have you thought about supporting the Early Ford V-8 Foundation Museum?

Last edited by VeryTangled; 04-10-2019 at 09:44 PM.
VeryTangled is offline   Reply With Quote
Old 04-10-2019, 10:06 PM   #17
cas3
Senior Member
 
Join Date: Jan 2011
Location: sw minnesota
Posts: 4,541
Default Re: White vinegar as radiator flush

an old radiator man told me once, never put acid in a radiator as it will attack the solder first. just sayin
cas3 is offline   Reply With Quote
Old 04-10-2019, 10:27 PM   #18
woofa.express
Senior Member
 
woofa.express's Avatar
 
Join Date: Jan 2018
Location: Tocumwal, NSW, Australia
Posts: 1,744
Default Re: White vinegar as radiator flush

Quote:
Originally Posted by cas3 View Post
an old radiator man told me once, never put acid in a radiator as it will attack the solder first. just sayin

I wonder if that is why the solder joint failed on my A. It was a pressurized (4 pound) radiator and nearly new. it was straight vinegar.
__________________
I know many things,
But I don't know everything,
Sometimes I forget things.

And there are times when I have a long memory.
woofa.express is offline   Reply With Quote
Old 04-10-2019, 11:06 PM   #19
Tinker
Senior Member
 
Tinker's Avatar
 
Join Date: May 2010
Location: MN
Posts: 7,053
Default Re: White vinegar as radiator flush

Model A radiators were never pressurized. I wouldn't leave vinegar in for a long time, but it's really a very very mild acid. It'd take a long time to eat away on any type of metal. In my opinion.


Something like rust911 would probably be best. chelate. It's somewhat a citric acid based. You can buy citric acid in bulk and mix it to whatever percent you like.

https://www.amazon.com/Milliard-Citr...ECZRBW2D7ZW17F


https://www.garagejournal.com/forum/...ad.php?t=69793





.

Last edited by Tinker; 04-11-2019 at 12:28 AM.
Tinker is offline   Reply With Quote
Old 04-11-2019, 06:31 AM   #20
tubman
Senior Member
 
tubman's Avatar
 
Join Date: Dec 2013
Location: Minnesota, Florida Keys
Posts: 10,260
Default Re: White vinegar as radiator flush

To be perfectly clear, "Rust-911" and "Evaporust", while "Chelates" are NOT citric acid based. I mixed up a batch of citric acid and tested it with pH test strips. it tested out as quite acidic. When I checked "Evaporust" the same way, it tested absolutely neutral. It's time to put this one to rest.
tubman is offline   Reply With Quote
Reply

Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump

Sponsored Links (Register now to hide all advertisements)


All times are GMT -5. The time now is 12:39 PM.