|
Sponsored Links (Register now to hide all advertisements) |
|
|
Thread Tools | Display Modes |
05-28-2020, 12:52 PM | #1 |
Senior Member
Join Date: May 2010
Posts: 2,871
|
Honing wheel & Master Cylinder
Rumble Seat, (bless his soul), recommended using cutting oil to hone with so you get a better finish. This may have been written before water based cutting fluids started to supplant oil/sulphur cutting fluids. The water base might be a lot easier to clean out after honing, but would it give the same finish as the old stuff ? Any experiences to share ? Thank you Fordbarners.
|
Thread Tools | |
Display Modes | |
|
|
Sponsored Links (Register now to hide all advertisements) |
|