Go Back   The Ford Barn > The Swap Meet > For Sale > Early V8

Sponsored Links (Register now to hide all advertisements)

Reply
 
Thread Tools Display Modes
Old 11-22-2020, 03:52 PM   #1
Ronnieroadster
Senior Member
 
Ronnieroadster's Avatar
 
Join Date: Dec 2010
Location: East Coast in CT
Posts: 882
Default Aluminum cam gear with additional holes to advance or retard cam position

City: Wallingford
State: CT
Price: 80.00

Sponsored Links (Register now to hide all advertisements)
Here's an nice used aluminum cam gear stamper B&D that besides the stock bolt holes also has additional bolt holes to allow advancing or retarding the cam position from the stock location. The gear teeth pitch angle is the early style used from 1932 to 1948 this allows the cam to thrust towards the block. The center hole has been opened up so it can also be used on the later style cam allowing clearance for the distributer drive gear. The amount of degrees changed by using the additional advance or retard location is unknown.
The price is $80.00 this includes shipping in the USA
Attached Images
File Type: jpg IMG_0270.jpg (32.8 KB, 9 views)
File Type: jpg IMG_0271.jpg (32.8 KB, 5 views)
File Type: jpg IMG_0272.jpg (23.7 KB, 6 views)
__________________
I use the F word a lot no not that word these words Flathead , Focus and Finish.
"Life Member of the Bonneville 200 MPH Club using a Ford Flathead block"
Owner , Builder and Driver of the First Ford Flathead bodied roadster to run 200 MPH Record run July 13, 2018 LTA timing association 200.921 from a standing start in one and a half miles burning gasoline.
Ronnieroadster is online now   Reply With Quote
Sponsored Links (Register now to hide all advertisements)
Reply

Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump

Sponsored Links (Register now to hide all advertisements)


All times are GMT -5. The time now is 08:46 AM.