Missing hand throtle part

[zoegrant]

On my 36 coupe which has a flathead with a Ford EAB carb there was a piece that connects the hand throttle rod to the carb...well it fell off on a ride the other day. The missing part appeared to be bronze or brass and was shaped like a little helmet and inside was a spring. This little helmet fit over a( T )shaped piece that the hand throttle rod is hooked to.
Anyone know what I am talking about ? If so, where can I get one and what is it called ?

[FlatheadTed]

Zig you will need to buy the whole length of rod that is joined under the dash its about 3 ft and crimped to the dash knobs ,any early Ford suplier such as Carpenter ,Macs ,Speedway ,

[Terry,OH]

Vintage Speed has nearly all the parts for the 94. Check out their web site. What ya doing with a EAB on a 36? How about a photo of your engine.

[deuce lover]

This what you need?

[GaryU.]

If what deuce posted is the part (my thoughts as well), you should contact CharlieNY as he probably has a box of them for his carb repairs.

[tubman]

Sponsored Links (Register now to hide all advertisements)

And it bears repeating again. "Charlie NY" will serve you a LOT better than "Charlie Price" (Vi8ntage Speed).

[terry]

Help me out deuce lover, does that end piece on the right also have holes in it to put a holder through, as well, to keep it from falling off the shaft? At least that is what's on my throttle at the carb on my 36. A cotter pin will suffice here.

[zoegrant]

Thank you Deuce...just what I needed....bought one on Ebay….

[scicala]

Originally Posted by terry

Help me out deuce lover, does that end piece on the right also have holes in it to put a holder through, as well, to keep it from falling off the shaft? At least that is what's on my throttle at the carb on my 36. A cotter pin will suffice here.

The piece on the right is slotted inside the hole. You push it in against the spring/lever and then rotate it 90 degrees to lock it on the throttle shaft.

Sal

[Terry,OH]

The above parts are for the 94 if you have a Stromberg they look like the pieces below which use a tapered pin to fit into a hole in the throttle shaft for attachment.

[terry]

Yes, that's my set-up on my Stromberg 48. Thanks, Terry. Didn't mean to confuse people. terry