|
10-01-2013, 07:27 PM | #1 |
Junior Member
Join Date: Feb 2011
Location: West Union Ohio
Posts: 20
|
cutting out
I have a 41 engine it is a stock engine and when you accelerate just when the engine starts pulling good it cuts out . I have changed the coil even put a new divorced coil on it. I have changed the inner caps on the distributor changed the wires,plugs,points checked all connections. I even put a new carb on it. the engine has around a 900 miles on it fresh fuel good compression and fuel pressure.The engine starts quick at any temp when it idles it is fine starts cutting out about 1/3 throttle. Now what do I do
__________________
NEVER GIVE UP |
10-02-2013, 02:36 AM | #2 |
Senior Member
Join Date: May 2010
Location: Oamaru, New Zealand
Posts: 419
|
Re: cutting out
Sounds like its not getting enough gas. Perhaps an air leak between the fuel pump and the gas tank?
|
Sponsored Links (Register now to hide all advertisements) |
|
10-02-2013, 04:04 AM | #3 |
Senior Member
Join Date: May 2010
Location: Solihull, England.
Posts: 8,744
|
Re: cutting out
HT breakdown between the rotor and the distributor shaft. Try a new rotor and some shrink tubing on the shaft.
Can't guarantee this is the problem, but it could be. From my experience, 90% of my problems have been ignition related, and 90% of those have been HT side related. Mart. |
10-02-2013, 06:20 AM | #4 |
Senior Member
Join Date: May 2010
Location: Lehighton Pa
Posts: 1,085
|
Re: cutting out
Sponsored Links (Register now to hide all advertisements)
|
|
|
Sponsored Links (Register now to hide all advertisements) |
|