Go Back   The Ford Barn > General Discussion > Early V8 (1932-53)

Sponsored Links (Register now to hide all advertisements)

Thread Tools Display Modes
Prev Previous Post   Next Post Next
Old 05-12-2020, 08:25 PM   #1
Join Date: Mar 2012
Location: Waterloo,CA
Posts: 48
Default '75 pinto 10" rotor and caliper

I'm sure this has come up in the past but i searched for it and got nothing. I have a '34 sedan with mustang front end. The caliper has a casting number 4109 and an emblem " Ford". It has a 10" rotor that was a 4 bolt rotor but it has been redrilled for 5 studs. I measured it and got 4.25" spacing but maybe i measured wrong because all i can find for 10" is either 5" or 4.75" or 4.5". Any one have any experience with this setup??
I want to get new rotors, calipers and pads.
jmerson is offline   Reply With Quote

Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump

Sponsored Links (Register now to hide all advertisements)

All times are GMT -5. The time now is 12:23 PM.