Go Back   The Ford Barn > General Discussion > Model A (1928-31)

Sponsored Links (Register now to hide all advertisements)

Reply
 
Thread Tools Display Modes
Old 02-09-2019, 09:25 PM   #1
Paul Bjarnason
Senior Member
 
Join Date: Jul 2018
Location: Annandale, VA
Posts: 150
Default Staying warm in winter

I want to drive in the winter without being uncomfortable. I don't want to cut a hole in the firewall of my '29 Tudor and I don't want to clutter up my passenger compartment with a little heater box. So, what to do?! For years I rode a motorcycle in the winter (Washington DC area) and had a heated vest and hand grips. My last VW had heated seats, which I loved. Has anyone put aftermarket heating pads under the upholstry of their Model A -- or tried a heated motorcycle vest? I am going 12 volt with a 60 amp alternator, so I think my system could handle a vest or heated seats. Thoughts and experience would be appreciated. Thanks.
Paul Bjarnason is offline   Reply With Quote
Old 02-09-2019, 09:51 PM   #2
coatings03
Member
 
Join Date: May 2013
Location: Seal beach,CA
Posts: 68
Default Re: Staying warm in winter

Yes,
Heated seats work well in a 12 volt system. I have a 29 open top speedster. I put March je moisture resistant seat heater. Works great, has a high low switch and middle position is off.

Jim m,
Seal beach. Ca
coatings03 is offline   Reply With Quote
Sponsored Links (Register now to hide all advertisements)
Old 02-09-2019, 09:57 PM   #3
30 Closed Cab PU
Senior Member
 
Join Date: Aug 2018
Posts: 2,332
Default Re: Staying warm in winter

Quote:
Originally Posted by coatings03 View Post
Yes,
Heated seats work well in a 12 volt system. I have a 29 open top speedster. I put March je moisture resistant seat heater. Works great, has a high low switch and middle position is off.

Jim m,
Seal beach. Ca


Any idea about what the current draw is?
30 Closed Cab PU is offline   Reply With Quote
Old 02-09-2019, 10:35 PM   #4
BILL WILLIAMSON
Senior Member
 
BILL WILLIAMSON's Avatar
 
Join Date: Dec 2010
Location: FRESNO, CA
Posts: 12,560
Default Re: Staying warm in winter

Move to a warmer climate!!
Bill Comfy
__________________
"THE ASSISTANT GURU OF STUFF"
BILL WILLIAMSON is offline   Reply With Quote
Old 02-10-2019, 12:02 AM   #5
Charlie Stephens
Senior Member
 
Join Date: May 2010
Location: Southern California
Posts: 7,017
Default Re: Staying warm in winter

Remember if you make the alternator belt tight enough to put out 60 amps you will wear out the front bearing of the water pump. How many amps does the electric heater draw? I would use an era correct hot water heater and put the holes in the floorboard. Of course in Southern California I don't have a problem (by the way, where in general do you live?).

Charlie Stephens
Charlie Stephens is offline   Reply With Quote
Old 02-10-2019, 12:26 AM   #6
40 Deluxe
Senior Member
 
Join Date: May 2010
Location: now Kuna, Idaho
Posts: 3,774
Default Re: Staying warm in winter

Sponsored Links (Register now to hide all advertisements)
Quote:
Originally Posted by BILL WILLIAMSON View Post
Move to a warmer climate!!
Bill Comfy

If we did that, you'd complain about all the traffic!
40 Deluxe is offline   Reply With Quote
Old 02-10-2019, 01:38 AM   #7
Dodge
Senior Member
 
Join Date: Nov 2011
Location: Sonoma, CA.
Posts: 1,491
Default Re: Staying warm in winter

Eat more beans, I agree with the hot water heater. I have a period correct one in the rear floor
Of my Tudor Sedan works great. No fan it just radiates.
I do want to try the heated seats in my Roadster though.
Dodge is offline   Reply With Quote
Old 02-10-2019, 03:55 AM   #8
burner31
Senior Member
 
burner31's Avatar
 
Join Date: Dec 2014
Location: Shawnee, Ok
Posts: 3,471
Default Re: Staying warm in winter

Original equipment is the only way to go...
Attached Images
File Type: jpg 6dabf2d2125965b4a5b7b15f89d30cd0.jpg (14.7 KB, 215 views)
File Type: jpg 8q7USps.jpg (31.6 KB, 203 views)
File Type: jpg 1694903_200x200.jpg (12.3 KB, 183 views)
File Type: jpg betty-grable.jpg (11.2 KB, 153 views)
File Type: jpg nqsg3d.jpg (9.7 KB, 170 views)
File Type: jpg x-arcade-card-mack-sennett-comedies-woman-in-wooly-bathing-suit-and-scarf-cap-on-car-running-boa.jpg (20.1 KB, 162 views)
File Type: jpg Lily_Munster.jpg (7.9 KB, 204 views)
__________________
Keith
Shawnee OK
'31 SW 160-B
burner31 is offline   Reply With Quote
Old 02-10-2019, 06:41 AM   #9
tinman080
Senior Member
 
tinman080's Avatar
 
Join Date: Oct 2015
Location: Forest, Virginia
Posts: 250
Default Re: Staying warm in winter

Mother!!!! No!!! IT CAN'T BE!!!!
__________________
Just Passin' Thru.....Slowly!
tinman080 is offline   Reply With Quote
Old 02-10-2019, 08:56 AM   #10
Paul Bjarnason
Senior Member
 
Join Date: Jul 2018
Location: Annandale, VA
Posts: 150
Default Re: Staying warm in winter

Quote:
Originally Posted by Charlie Stephens View Post
Remember if you make the alternator belt tight enough to put out 60 amps you will wear out the front bearing of the water pump. How many amps does the electric heater draw? I would use an era correct hot water heater and put the holes in the floorboard. Of course in Southern California I don't have a problem (by the way, where in general do you live?).

Charlie Stephens

Seems like 10 amps for two seats on the high setting. But, additional wear on the water pump bearing is a good point, Charlie. I live in the Washington DC area (Northern Virginia). Here's what WATERCARBON brand seats say: Water Carbon each seat includes two pads - One for the Seat Back and One for the Seat Bottom. Two Kits are included to Accommodate two seats. Each Heater Has Three Settings - High, Low and Off. Dual Temperature Control System. Electronic thermostat (built into each pad) regulates the electricity / temperature circulating within the carbon fiber seat heating pad. This system regulates the flow of power and maintains a narrower temperature range whether in a high or low setting. Example: The high setting will have a constant range between 120°F to 125°F. The low setting ranges between 110°F to 115°F. These respective temperatures are maintained at these respective levels. Backrest & Seat Bottom Heating Pads -- 11" x 17.5" Pads are approximately 1/32" thick. Either pad can be installed in back or bottom. Length can be trimmed to any size. Electrical Specs Wattage: 24-36 Watts per Pad, 48-60 Watts per seat Current Draw: 3 Amps on Low Heat Setting and 5 Amps on High Setting per Seat. It is a 12 V system. If you have always wanted to add factory like heated seats to your Vehicle or Boat, then this Heated Seat kit is the ideal kit and the ideal solution whether you own a car, SUV, Truck, Boat or Plane. Carbon Fiber technology is the best seat heating pad material in the marketplace. Installation may require removal and re-installation of seat and seat covers, as well as basic knowledge of the vehicle's wiring or professional installation.


https://www.amazon.com/Premium-Unive...YDYE2K9THTR18S
Paul Bjarnason is offline   Reply With Quote
Old 02-10-2019, 09:09 AM   #11
Chuck Dempsey
Senior Member
 
Chuck Dempsey's Avatar
 
Join Date: May 2010
Location: Waynesville, NC
Posts: 777
Default Re: Staying warm in winter

Paul, check out this thread from a few years ago on heaters that DON'T require firewall holes. Floorboard vents are used instead.
Chuck Dempsey is offline   Reply With Quote
Old 02-10-2019, 09:28 AM   #12
BILL WILLIAMSON
Senior Member
 
BILL WILLIAMSON's Avatar
 
Join Date: Dec 2010
Location: FRESNO, CA
Posts: 12,560
Default Re: Staying warm in winter

[B]In the OLD Surplus Stores, I'd buy electrically heated Flight Suits & matching hats for my Roadster. They were 24 Volts & the plugs were cut off, to a nub! For rain, I cut two head holes, in a Surplus, heavy tarp.
Bill Dryandwarm/B]
__________________
"THE ASSISTANT GURU OF STUFF"
BILL WILLIAMSON is offline   Reply With Quote
Old 02-10-2019, 09:30 AM   #13
Paul Bjarnason
Senior Member
 
Join Date: Jul 2018
Location: Annandale, VA
Posts: 150
Default Re: Staying warm in winter

Quote:
Originally Posted by Chuck Dempsey View Post
Paul, check out this thread from a few years ago on heaters that DON'T require firewall holes. Floorboard vents are used instead.

Chuck - What thread is that? Got a link? Thanks. Bj
Paul Bjarnason is offline   Reply With Quote
Old 02-10-2019, 09:41 AM   #14
jb-ob
Senior Member
 
Join Date: Jun 2010
Posts: 631
Default Re: Staying warm in winter

'Era Correct' would have been a 1/5th under the seat......
jb-ob is offline   Reply With Quote
Old 02-10-2019, 10:11 AM   #15
jw hash
Senior Member
 
jw hash's Avatar
 
Join Date: May 2010
Location: Auburn Washington
Posts: 2,550
Default Re: Staying warm in winter

on my 160A four door, I to did not want to cut a hole in the firewall. so I found this heater manifold. it goes through the wood part of the floor and it keeps the inside nice and toasty, I can feel the hot air blowing in my face.
Attached Images
File Type: jpg Scan0002.jpg (17.9 KB, 189 views)
jw hash is offline   Reply With Quote
Old 02-10-2019, 10:41 AM   #16
gary678*
Senior Member
 
Join Date: Dec 2016
Location: Middletown, NY
Posts: 162
Default Re: Staying warm in winter

Wire in a 12 volt receptacle in an inconspicuous spot in the cab and plug in electric blanket(s) to sit on as needed. Simple installation, very low cost, and electric blanket(s) can be stored out of car until needed.
gary678* is offline   Reply With Quote
Old 02-10-2019, 10:53 AM   #17
rfitzpatrick
Senior Member
 
Join Date: May 2018
Location: Coral Springs, Florida
Posts: 547
Default Re: Staying warm in winter

Is that what's called a Running-Board Heater? Number 6 from the top
rfitzpatrick is offline   Reply With Quote
Old 02-10-2019, 11:07 AM   #18
Aretino
Senior Member
 
Aretino's Avatar
 
Join Date: Jul 2018
Location: Dallas, TX, Angola, IN
Posts: 157
Default Re: Staying warm in winter

Johnnie hand warmer. Had one in both coat pockets while delivering newspapers in Waterloo
Aretino is offline   Reply With Quote
Old 02-10-2019, 11:07 AM   #19
Chuck Dempsey
Senior Member
 
Chuck Dempsey's Avatar
 
Join Date: May 2010
Location: Waynesville, NC
Posts: 777
Default Re: Staying warm in winter

https://www.fordbarn.com/forum/showt...orboard+heater
Sorry, forget the link. Thanks for the remind.....
Chuck Dempsey is offline   Reply With Quote
Old 02-10-2019, 11:10 AM   #20
Brendan
Senior Member
 
Brendan's Avatar
 
Join Date: May 2010
Location: At my kitchen table in Santa Rosa, Ca
Posts: 2,902
Default Re: Staying warm in winter

Quote:
Originally Posted by burner31 View Post
Original equipment is the only way to go...
who is the woman in the second photo, she can keep me warm
__________________
If it would have been a snake it would have bit ya!

i can't spell my way out of a paper bag!
Brendan is offline   Reply With Quote
Reply

Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump

Sponsored Links (Register now to hide all advertisements)


All times are GMT -5. The time now is 05:06 AM.