The Ford Barn

Mr. Ed · 10-09-2018, 10:06 AM

I have a good housing that I bought after ours was found to be so rusted that it's only value is as a paper weight. So I am looking to buy:

Upper plate
Lower plate
Points
Condenser
Hardware pack
Rotor
Cap
Distributor body
Coil
"Wires"

I checked prices between several vendors and I have a list compiled of who has what and their costs. And from working on old cars for years and buying from some of these vendors, I see Mac's is still higher than the others. Nice to see there are some constants in the world today.

Am I missing anything?

Later!
Mr. Ed

Bob C · 10-09-2018, 10:23 AM

Bushings, shaft, Stipe distributor cam, get A&L condenser.

Bob

katy · 10-10-2018, 09:30 AM

https://www.brattons.com/distributor...ock-parts.html

Or: https://www.brattons.com/distributor...dern-part.html

Mr. Ed · 10-10-2018, 01:30 PM

Thanks for the replies.

Later!
Mr. Ed

Preacher · 10-10-2018, 06:53 PM

Sponsored Links (Register now to hide all advertisements)

send me your rusty paperweight! I will pay the shipping

10-09-2018, 10:06 AM	#1
Mr. Ed Junior Member Join Date: Oct 2018 Location: South Jersey Posts: 13	Rebuilding a distributor I have a good housing that I bought after ours was found to be so rusted that it's only value is as a paper weight. So I am looking to buy: Upper plate Lower plate Points Condenser Hardware pack Rotor Cap Distributor body Coil "Wires" I checked prices between several vendors and I have a list compiled of who has what and their costs. And from working on old cars for years and buying from some of these vendors, I see Mac's is still higher than the others. Nice to see there are some constants in the world today. Am I missing anything? Later! Mr. Ed __________________ 1951 F-1, 351W, C-4, Henry. 1993 Mustang 5.0 LX convertible, Sally. 2006 Jeep Grand Cherokee Laredo, Herman.

10-09-2018, 10:23 AM	#2
Bob C Senior Member Join Date: May 2010 Location: So Cal Posts: 8,741	Re: Rebuilding a distributor Bushings, shaft, Stipe distributor cam, get A&L condenser. Bob

10-10-2018, 09:30 AM	#3
katy Senior Member Join Date: Jun 2015 Location: Red Deer, Alberta Posts: 5,042	Re: Rebuilding a distributor https://www.brattons.com/distributor...ock-parts.html Or: https://www.brattons.com/distributor...dern-part.html __________________ If you don't hear a rumor by 10 AM, start one!. Got my education out behind the barn!

10-10-2018, 01:30 PM	#4
Mr. Ed Junior Member Join Date: Oct 2018 Location: South Jersey Posts: 13	Re: Rebuilding a distributor Thanks for the replies. Later! Mr. Ed __________________ 1951 F-1, 351W, C-4, Henry. 1993 Mustang 5.0 LX convertible, Sally. 2006 Jeep Grand Cherokee Laredo, Herman.

10-10-2018, 06:53 PM	#5
Preacher Senior Member Join Date: May 2010 Location: Minnesota Posts: 198	Re: Rebuilding a distributor Sponsored Links (Register now to hide all advertisements) send me your rusty paperweight! I will pay the shipping

Thread Tools
Show Printable Version Email this Page
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode