|
Sponsored Links (Register now to hide all advertisements) |
|
|
Thread Tools | Display Modes |
10-15-2013, 05:16 PM | #1 |
Senior Member
Join Date: May 2010
Location: Oakdale,Ca
Posts: 1,323
|
'42-47 pickup drive shaft
City:
Oakdale
State:
Ca
I need a driveshaft for a '42-47 PU...tranny yoke not needed.
This is for a short wheelbase PU...1/2 ton. Thanks |
10-15-2013, 05:51 PM | #2 |
Member
Join Date: May 2010
Location: Huntington Beach, CA
Posts: 54
|
Re: '42-47 pickup drive shaft
How long is the shaft? I have a shaft leaning up agsinst the fence that I will give away. Need to know how long you need.
Jerry Hurt [email protected] |
Sponsored Links (Register now to hide all advertisements) |
|
10-16-2013, 03:09 PM | #3 |
Senior Member
Join Date: May 2010
Location: Oakdale,Ca
Posts: 1,323
|
Re: '42-47 pickup drive shaft
Hi Jerry,
I know the actual tube itself is 59 inches..I'll have wait till my nephew gets home for he can hold one end of the tape for me, and I'll email you UJoint center distance. Center of U-Joint to U-joint is 62 The tube is 3.5 inches in diameter. PS.. If it's longer, no issues, as long as it's one piece. Thanks Last edited by Mike B; 10-23-2013 at 03:30 PM. |
10-23-2013, 03:31 PM | #4 |
Senior Member
Join Date: May 2010
Location: Oakdale,Ca
Posts: 1,323
|
Re: '42-47 pickup drive shaft
Sponsored Links (Register now to hide all advertisements)
|
|
|
Sponsored Links (Register now to hide all advertisements) |
|