The Ford Barn

Bob from Northport · 09-10-2021, 09:40 PM

Can anyone advise the correct ID for the rear drum hub where the bearing fits into?

john charlton · 09-11-2021, 01:09 PM

Just measured one where the seal fits and get 3 3/16 "

John in lovely autumn warm sunny evening Suffolk County England .

Synchro909 · 09-11-2021, 08:34 PM

Sponsored Links (Register now to hide all advertisements)

Just about every original rear hub is worn out by now. They wear most at the axle nut end and if left in service, will cause the axle to break. They are no different from anything else on the car. If you want it to perform well, keep it in good condition.

09-10-2021, 09:40 PM	#1
Bob from Northport Senior Member Join Date: May 2010 Location: 215 E. 6th Street Northport, Michigan 49670 Posts: 941	Rear drum question Can anyone advise the correct ID for the rear drum hub where the bearing fits into? __________________ Bob from Northport Northport, Michigan

09-11-2021, 01:09 PM	#2
john charlton Senior Member Join Date: May 2010 Posts: 1,304	Re: Rear drum question Just measured one where the seal fits and get 3 3/16 " John in lovely autumn warm sunny evening Suffolk County England .

09-11-2021, 08:34 PM	#3
Synchro909 Senior Member Join Date: Jun 2014 Location: Melbourne, Australia Posts: 7,496	Re: Rear drum question Sponsored Links (Register now to hide all advertisements) Just about every original rear hub is worn out by now. They wear most at the axle nut end and if left in service, will cause the axle to break. They are no different from anything else on the car. If you want it to perform well, keep it in good condition. __________________ I'm part of the only ever generation with an analogue childhood and a digital adulthood.